How do i remove the housen to clean the fans - The Computers & Internet

Sound like a blown fuse or a ground wire off I know there one on tranny bell housen

Use a vacuum cleaner, the small round end.

that is the engine temp sensor.

Sounds like it got knocked out of time. Take it in for repair.

take bracket off throd body then take therostat housen off to change therostat then put back together fill with coolent run with cap off it water goes down then fill on up put cap on drive and watch gage make shur it dont run hot

#1 CLEAN WORK SPACE
#2 PLACE FAN ON ITS CONTROL SIDE DOWN
#3 REMOVE PHILLIPS HEAD SCREW FROM HANDLE
#4 REMOVE NON-SKID COVERS
#5 REMOVE OTHER 2 PHILLIPS HEAD SCREWS
#6 REMOVE BLACK SIDE & CLEAN
#7 REMOVE YELLOW FAN COVER & CLEAN
#8 7/16 SPIN-TYPE DRIVER REMOVES FAN NUT
#9 CARE....WASHER ON OTHER SIDE OF FAN
#10 PUT FAN IN SOAP& WATER ....TAKE YOUR TIME

mcdevito75 here, Believe it or not, I use a good quality spray cleaner like Mr. Clean, a spray that removes dirt and then you wipe clean, I use the sray, let it soak, then with a garden hose clean it off. The fan motors are sealed so you don"t have to worry too much of water in the motors, still don't direct the water hose stream directly onto the fan motors, also allow the fan to dry real good, out in the sun. I never had a problem with mine useing this technique of cleaning.

I am certainly not an expert on this field; yet i have done this my self and this is what i did:

MOst fans have clips.
check where the from and back pieces attach. there should be several clips there remove them and voila.

if not there possibly check the centre pice of fan this may have a screw that holds front and back pieces together as well.

Pllease note you will also have to remove the legs from the side of fan as well. if the pic is the same one you have
Hope this helps
Roty:)
Never argue with an idiot
They bring you down to their level
Then they pummel you with experience

With a little more detail on how to clean the 84001. There are 2 screws at the top of the unit on the back side and 1 on the bottom with a small removable cover. Remove those screws and the cover can be removed.
There will be some resistance towards the middle because of 2 clips on both sides. Be carefull not to pull too hard on the ends ; possibility of breaking the cover. Try pressing on center of the cover on one side of the edge.
There are 2 screws holding a bracket that holds the top of the fan. Remove those screws. Then on the bottom there is a shaft that attaches to the motor. You will find a set screw that you need to loosen. When you loosen and remove squirrel cage you will notice a flat spot on shaft. That is where the set screw is to be put when assembling the fan back together.
After cleaning just follow the steps back to assemble your 84001 and enjoy a clean brisk breeze. I hope this helps explain in more detail on how to clean it.

Check the fuses in the small pcb in the middle of the front door. If they are ok. it's the amp end of things.