Nespresso Krups essenza manual XN2001- Switch broken

OK fill the tank and only use water press the small cap botton and after 5 seconds stop the machein and do the same again untill the pump gets the water into the system

My Krups Nespresso XN2005 machine turns itself off when I try press the start button- any solutions ?

Sounds like a defect in the main board. Call Krups customer support for what the options are in replacing the machine. This is not caused by yourself.

I opened mine when this did this - it also happened to my second Magimix Nespresso Manual machine. A short pipe carrying pressurized water had burst. I called Nespresso . parts were not available and they offered me a new half-price machine. We are talking a 4 inch piece of plastic tubing here. Shame on you Nespresso for encouraging me to throw what is otherwise a fine machine....

I had a similar problem where both Small and Large cup buttons on mine blinked intermittently. I did a reset of the large and small cup flow levels based on the following and it seems to work fine now:
1. Switch off power 2. Press and hold Large cup button 3. Switch on power while still holding down large cup button
See if that solves your problem.

My guess is that the Essenza is in 'Descaling' state. See section 7 of the essenza manual. To get out of it, hold both the buttons down for 3 secs. The lights will then blink at normal rate for a bit and then turn solid.

That is a faulty thermostat or a defective control board.

Contact Krups and have the machine replaced.


Contact - Krups International

This machine does not have that muck electronic, the button switch has probably a short, and must be replaced.

As said the machine is Krups, and therefore should be covered with one year warranty. Call the number listed on the user manual, or find contact from websites below:

Coffee & Espresso Machines - Small Domestic Appliances - Krups

Home - Krups UK

reset to factory default...

1. Power switch off
2. Press & hold coffee cup button while powering back ON