My question is,I air sprayed all the dust off it,is this good enough,or is there more,or do I replace it and if so where do I purchase this filter for my projector?
SOURCE: sony vpl-hs20 cineza projector- reset lamp counter
These instructions are for a Sony Cineza VPL HS3, but may be the same for the HS3.
1st thing to check - is the cover properly/completely closed - this can stop the projector from working.
Connect the power and set the projector to standby mode.
Press these buttons on the remote control in this order, for less than 5 seconds each.
Reset - Left Arrow - Right Arrow - Enter
This is required, to reset the lamp timer.
Also, something I found interesting from the internet - lamp life isn't
when the bulb dies, but when a bulb has lost 10% of its brightness - so
you might well be able to reset the timer and get much more use from
the bulb - the image just wont be as bright.
SOURCE: HOW TO REPLACE FILTER "SONY PROJECTOR MODEL VPL-HS3"???
http://www.manualowl.com/m/Sony/VPLHS3/Manual/789?page=38
Testimonial: "Thank you very very much @SD Tech ... God bless !!!!"
97 views
Usually answered in minutes!
×