How do I clean the plunger on nelson solorrain 8014?

.
can see how it ended up on toys category

...


JCB 8014 8016 8018 8020 Mini Excavator Workshop Service Manual eBay

change the battery; read the manual..

Mode key

make sure the dull side is facing the paper

If it is actually spraying, yes. But if it isn't, no

Remove the ribbon, pull back on the black lever on the R. edge of the print wheel.

DickyO

Buy a new timer. Sounds like the circuit board has a short. or call the manufacturer number should be in the instructions.

Nelson Appliance has this: http://goo.gl/bsjqj. I think this is what you are looking for. The description they give is: Boiler center gasket / seal #MS-5015004 for use with Krups XP7000 series espresso machines.

reset daisey wheel on tandy word processor

I made mine stay on by wrapping a plastic tie wrap around the shaft of the stopper between the stopper head & where the stopper shaft enters the housing. It must be wide enough to keep the plunger/stopper from going into the housing. Hope this helps. God Bless You!!! Darrell