"Antenna" Appears on Roady XT Display

Go outside with the unit in the clear, and If it says "Antenna" - it means the connector for the antenna, the docking base or the antenna itself it usually bad. See if you can borrow a buddy's antenna just to see if the "Antenna" warning goes away. It could be the antenna & its connector, could be the docking base (make sure the radio is plugged in tight) or could be the radio (but usually isn't). Good luck and let me know what you find out.

yes. Just plug in the antenna from the XT base into the Onyx base, plug in power and activate!

It is surely the antennae. I have had to replace mine a few times too. The thing is, where it bends, like near the plug connection and near the actual antennae wire connection, it just fractures a bit and that's it.
Pick yourself up a new one on eBay or Amazon, and no, there aren't really heavy duty ones and that wouldn't fix it, it is the wire getting worn.
Good luck!

one of 3 things, either your antenna is not insight of a skies view to receive the signal, or its wire is broken at the antenna, but if you remove the antenna connection frequently it pulls the center wire out of the connection on the end that fits into the radio when its plugged in push on the conductor at the back of the plug and see if this helps,alos if connection is loose take a safety pin and carefully between the outer plug case ans the ground fingers around the center pin push these in so you get a better ground, and lastly try another substitute antenna, I have re-soldered my connections numerous times to fix this issue, delphi doesn't make a very rugged product, good luck

when it reads antenna it means there something wrong with either the connection or the antenna itself, it could be the location of the antenna or the antenna is going bad. if there is no obstructions on the car blocking the antenna i would advise purchasing a new antenna. you can get one at http://shopdelphi.com/consumers/satradio/xpressrc/

I have the same problem. I hooked it up to a different antenna and it works

I have the same problem... I found using a new cradle solved the problem.

You need to replace the transformer that plugs into the wall.

I had the same problem with all three of my Roady XTs. I posted a video with directions for solving the problem on YouTube:

http://www.youtube.com/watch?v=BGMWf0aUTjw

Basically, you just need to have the antenna unplugged when you power up, and push menu right away, then select. Not sure why, but it worked on all of my Roady XTs. On the oldest one I had to push menu more than once. Good luck!

Chances are it's not picking up the XM signal. First, contact XM to resend your setup. if that doesn't work check your antenna connections.