Seeking the study commissioned by Jacuzzi on luxury baths

The flashing on/off light in a Jacuzzi whirlpool bath may indicate an issue with the control system, and it's important to address the problem to ensure the proper functioning and safety of the whirlpool bath. Here are some general steps you can take to troubleshoot the issue:
1. Check the Power Supply:
- Ensure that the whirlpool bath is receiving power. Verify that the circuit breaker for the whirlpool bath is not tripped, and check for any loose or disconnected power cords.
2. Inspect the Control Panel:
- Examine the control panel for any visible issues, such as loose or damaged wires, connectors, or buttons. Ensure that there is no water or moisture present in the control panel area.
3. Reset the System:
- Some whirlpool baths have a reset function. Turn off the power to the unit, wait for a few minutes, and then turn it back on. This can sometimes reset the control system.
4. Refer to the User Manual:
- Check the user manual that came with your Jacuzzi whirlpool bath for specific information on troubleshooting and resetting the control system. The manual may provide insights into the meaning of the flashing light and how to address it.
5. Contact Jacuzzi Customer Support:
- If the issue persists and you cannot find a resolution through the manual, contact Jacuzzi customer support or the manufacturer for assistance. They may be able to provide guidance on how to troubleshoot and resolve the issue.
6. Professional Inspection:
- If you're not comfortable or able to identify and fix the issue, it's advisable to seek assistance from a qualified professional or a technician experienced in Jacuzzi whirlpool bath systems. They can perform a thorough inspection and diagnose and repair any electrical or control system problems.
It's essential to prioritize safety and follow proper procedures when dealing with electrical components and water. If you're uncertain or if the troubleshooting steps don't resolve the issue, it's best to seek professional assistance to avoid potential hazards.

Bath Panels can be very difficult to locate. I would check with your local Jacuzzi Showroom first.
If they are unable to locate the panels you need or they are no longer made then you should head over to Lowes or Home Depot to get a generic panel from one of them and you may need both panels replaced so they match.

rod
US parts Center
Bath Spa Replacement Parts Hot Tub Bath Parts Accessories US Parts...

Try here: http://jacuzzicare.com/index.php?main_page=&gclid=CNmIgofei7cCFYHc4AodBmYAPQ OR: http://www.jacuzzi.com/baths/pdf/MPD.PDF

so that is it, why do dirt come out of jets when on

Jacuzzi Cetra Comfort Bath home page:

http://www.jacuzzi.com/baths/options/models/cetra

Installation and Operating Instructions:

http://www.jacuzzi.com/admin/files/files/4cfd8269-e7b0-4286-9908-7b9743.pdf

For replacement parts your best bet is to you use the on-line dealer locator:

http://www.jacuzzi.com/baths/pages/dealer-locator

or you can shop on-line from one of their authorized retailers; however did not see any of the parts you are looking for at the sites I checked:

http://www.jacuzzi.com/baths/pages/buy-online

Start by using denatured alcohol. If that doesn't do the trick you can use acetone but be extremely careful with that stuff because it can melt plastic

It sounds as if the relay is not latching on the circuit board for that tub. You probably want to have a Jacuzzi service tech come and take a look at it.

go to jacuzzi.com - downloads

Just clean it once a week is fine.

Please rate!