I have a Dewalt DW DO24 drill with a wire out and don't know which terminal its from. Do you have a wiring diagram pleas?

Here are the wire placements for the switch of a DeWalt DWD520 hammer drill:

1. The red wire from the motor goes to the top left terminal on the switch.
2. The black wire from the motor goes to the top right terminal on the switch.
3. The white wire from the power cord goes to the bottom left terminal on the switch.
4. The black wire from the power cord goes to the bottom right terminal on the switch.

It's always recommended to double-check the manual or contact DeWalt customer service for confirmation, as wire placement may vary depending on the specific model and year of manufacture.

The green wire is always the ground pin (ground connection)
Hope this helps.

The green wire is always the ground wire. It should be connected to the ground pin on the power connector.
Hope this helps.

look for a positive or negative + or - sign on the whitch kit. Wires the terminal and now your cord is attached to the tool dewalt dw 660 you are good to go. I add a diagram that may help you good luck.

get

https://servicenet.dewalt.com/Parts/Search?searchedNumber=dw400&searchType=0

you would need to replace the switch, the brake is internal. BEFORE removing the switch make a wiring diagram to help in reassembly and make sure the wires don't touch the motor. The switch is polarity sensitive. You can either get one from dewaltservicenet.com or ereplacementparts.com, you can also try and locate a service center or authorized repair in your area at the Dewalt site. Let me know if you need more assistance

go to dewalt website they should have it

I have fix my dewalt dw 056 with a switch comming from an old dewalt hammer drill that i had lying around if you find and older dewalt hamme drill with burn brushes u can interchange the switch ,they sell the repalcement new switch for around $56.00 here in canada its not worthed u can get a new refurbish dewalt impact for around $99.00 from toolking

Unfortunately, Dewalt does not provide wiring diagrams to the public. You may be able to get one from your local Dewalt service center. If you do not have one locally, Let me know what wires you are unsure of, maybe I can still help.

I fix cordless DeWalt drills every week!Look for two black carbon-like blocks found on either side of the commutator ( the central spindle ) they will each have one wire on the outside end attached to a spade connector so the brush can be easily removed by prying it out from beneath the spring holding the brush against the commutator.  Then the wire can be removed and the new brush installed.    Go online to http://www.toolpartsdirect.com and search for your model dewalt drill. they have an exploded diagram and parts listing for each model drill.  That will identify the brush for you if you have never seen one before.    If the drill was operating intermittently with lots of noise and usually blue sparks coming out, loss of power, increasing intermittant operation it would almost certainly benefit from replacing the brushes.   If it is simply dead, and was ever dropped.  check the battery terminals and the trigger mechanism.  Of course inspect the battery and check inside the drill for loose or broken wires and connections. I hope this is helpful. Good luck!