I misplaced my Manuel for my Skyscan Atomic clock. Model 88800/8880. I need to reset.

Look carefully at the back of your clock for a reset button. The temp may have encountered a problem and stopped working. Also, be sure the battery is fresh. Hope this helps.

Hello
Get into this link. You can see the user manual for your Skysacn atomeic clock here. You can adjust your clock according to it manual. OK.
http://www.atomicclocksstore.com/skyscan-atomic-clock-manuals

It does that until it receives a signal. Leave it overnight and it will probably get one. Instructions for this clock are at skyscaninfo.com

I have a skyscan Atomic clock model no 86730 and can't set it, every time i get it set, it goes back 1 hr, i need to know to set it to daylight savings time

link below will tell you how to set clock. scroll down about half way.

http://www.skyscan.info/content/manuals/15-model-28500.html

I had no problem, just wanted to know when SkyScan model 86709 would be in stock so I could order it.

Thanks for replying.

Ruth Ormsbee

Simple, the instructions state that when changing the batteries on the outside temp. sensor, you must also change the batteries on the main clock unit. I had same problem when I changed the sensor batteries until I pulled the batteries from the clock and it reset fine. ( Sensor batteries first, then clock batteries. ) The clock will reset to atomic time overnight so don't worry if it doesn't read correctly at first.

outdoor temp is not working

Online manual is at link http://skyscan.info/content/manuals/25-model-87315.html

Just did this after problem resetting after changing batteries, press setover and again til it displays est, then press+until your time zone is displayed, it will also display dst, press +till on/or off depending on your location, then US will appear, clock will then set itself. Good luck, how frustrating.