At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
There could be a list of different problems. Usually, the red lamp will blink in a particular sequence, which tells the tech which board is most likely the problem. This is not a 100% accurate, because another board that has an issue, could cause the first board to interpreted incorrectly by the microprocessor IC(computer within your TV)
Press and hold the SETUP button until the red indicator stays on, then release the SETUP button.
Press and release the desired Mode button (TV, VCR, etc.). The red indicator blinks, then stays lit.
Enter the 4 digit code from the code tables. Note: after a valid code entry, the red indicator turns off. For an invalid code, the red indicator flashes.
With your device on, press CHANNEL UP. If the device responds, no further programming is required. Note: If some buttons do not operate your device, try one of the other codes for your brand.
If I understand your problem correctly, it sounds like the unit is not coming on... If this is correct, then replace the 3 capacitors on the output side of the power supply. There are 2@1000uF @25V and 1 smaller one which is 220uF@25V. I think the part number on the board is marked as WX-15/19/20Power-01... This worked on a 19 curtis LCDVD191 Hope this helps...
1 - Hold the clear tv buttom until all 4 light flash red 2- Press the red tv buttom 3- Press the amount of time needed on the up cursor ( around select buttom) until your tv shut down 4-When the tv goes off press the search buttom ( at the end on the right side ) 5-Press record
Then u can use the red tv buttom to control ur tv and u can control the volume on satelitte mode without going back to tv mode , if u press too much time while searching the code and the tv wont light back , do the same thing but instead pressing the up cursor press the down one to go back on the code it will be faster .
This way of finder code make the remote search 1 by one , usually dvd and other things else than television dont work , but give it a try might work but probably will just power on and off not more than that but will work fine with ur tv
×