Belkin tower rack

User Manuals only. Contact them direct

http://www.belkin.com/support/dl/f6c1000-tw-rk.pdf

..

Wakeboard racks cost between $100-$650. For a complete list of tower racks for sale, check out this website: http://www.onlyinboards.com/AccessoryShop/Products/Racks/Wakeboard-Racks.aspx

For the price it will take to get it fixed, you can buy a brand new one. But if it is less then three years old, belkin will fix it for free.

Most Thule rack towers can simple be moved by pulling them straight out. They only lock on place when pressure is applied by mounting the racks. They can be stiff so try spraying some anti-seize spray on the underside of the tower where it comes in to contact with the cross bar as this can help a lot.

remove the battery. It will have a number on it also the voltage and amp hrs. You can find the battery online or if you have an interstate battery store near by they will have what you need.

Here's the manual with battery replacement instructions. If not detailed enough, give their support line a call.

http://cache-www.belkin.com/support/dl/f6c1500-tw-rk.pdf

Toll Free from USA: 1 800 2BELKIN

Yes, I was able to get it fixed.
The spray tower actually fits in the rack (I had thought it fit in the top of the lower spray arm - wrong!)

If you were to look at the spray tower itself, it has 2 little clip like plastic protrusions that with a little twist will clip onto the lower rack!

Push the lower rack in and you can see where the center would be, (right over the middle of the lower spray arm ).

Now pull out the rack and take the spray tower and slip it under the rack up thru the bottom in the position you noted was the center (from above).

Now with the spray tower in place, slide the rack back inside the dishwsher and you will see that the tower will be sitting directly over the top of the exact middle of the lower spray arm.

Voila!

It should work, make sure each profile is set the same way. Keep in mind you should still be able to utilize your standby feature, and your screensaver as well.

The Spray tower fits in the bottom rack, Its actually pretty obvious as there is no way it can sit int he position it has to without being in the rack itself otherwise the rack and tower would block each other all the time. 
 Examine the base of your spray tower it should have two "clips" or plastic protusions that will, with a circular twist, snap onto the bars of the middle of the rack itself. Then when in place and your rack is slid inside the dishwasher the tower should sit directly over top of the exact middle of your bottom spray arm. 
et Voila. 

I had the same problem finding a Water Tower laying in the bottom of the dishwasher. Solution is to simply lift the bottom rack and insert the tower into the center-most square hole. Twist the tower with the large lip on the bottom of the rack and the two plastic pieces will overlap two sides of the square hole. It will come lose again in time, but just reset it again.