Pioneer Media Receiver PDP-R06U "input 1" is totally inop. Switching HDI's to other input proves it is defective. Can it be reset? Otherwise the 2nd input is not available for DVD/BluRay, etc

no if it didn't have a tuner it would not even have a picture he is lying

Hi I also having the same model but the receiver is not working properly. So I don't no what to do.

Pioneer PRO-R06U

Any luck with this? I really need this information as well.

Hey,
This may be too late...
I got it from the field manual.

Trap Switch Reset Procedure
G-4, G-5, G-6, G-7, G-8
• Replace media receiver, plasma panel cover, or tape down HDCP trap switch.
If the model in question has the TV Guide option, the TV Guide
option must be turned off before proceeding.
• Using the customer’s remote control enter “service mode” by pressing the
following key sequence:
1. Press the “display” button then release the “display” button.
2. Wait between 3 and 7 seconds
3. Press and release the “<”, “^”, “<”, “>”, and “power” buttons in sequence.
• Panel will now turn on in “service mode”.
4. Press “muting” button 3, 4 or 5 times depending on model you are working on.
Until the display shows the “initialize” page.
5. Press and hold the “display” button until the error indicator (red LED) on
either the panel or the media receiver goes out.
6. Exit service mode by pressing the “power” button on the remote.

I had to try it a couple of times before I got it to work. I.m not too sure how to turn off the tv guide mode. I just held it in for a couple of sec,s.

Good luck

Alas, the powerblock has gone.

Common problem on this model.

Only solution is replacement powerblock.

Pioneer used to repair this for nothing even out of warranty (they did for me), but they may not be so willing now, as your tele must be at least 6 years old. Unfortunately, it will be cheaper to buy a new TV than to pay for a contractor to fix it.

Brian

On this model, this is a "fault code". The unit has attempted to power up and the processor has determined a fault with it's "self check" diagnostic test it runs each time the unit is turned on. A technician will have to test the unit to determine the nature of the fault.

You can use a PDPR06U if you can find one for sale its 2 generations later than your's. Look on Ebay. I might have one too but I got to look.

maybe its not worth the effort. the media or turner box must corsponed with the model of the pioneer tv, in order to work.

You need the pioneer media cables hooked up to the media receiver to the plasma unit itself. each end has 2 different plugs. one has 2 thumb screws and the other is a squeezable end that clicks into place. They MUST be on before you plug in any power what so ever!!!! And yes, other information is being passed through.

C-Dog