MTX Terminator Amp...Red light comes on when it should be green.

CHECK YOU CONNECTION YOU MAY HAVE PUT WIRE TERMINAL WRONG AN THE AMP GOES TO PROTECTION CHECK ALL SPEAKER TOO

on some amps there is a duel light. red and green usually. red means it is in protect mode or you didn't hook up your remote wire. if in protect mode, it could mean a number of things. did you hook it up with speakers and everything?

If none of the lights are coming on for the amp then the amp is not getting power and/or ground. Check the connections. Check the fuses. Or the amp is no good.

You may have touching speaker leads going into the amp. Make sure the tinsel is not touching across the speaker inputs on the amp. Also check your ground. It should be solidly connected to the vehicle chassis in a paint-free location. Finally, make sure there are no exposed speaker wires touching the vehicle chassis.

check the ground make sure its not loose from the frame of your car thats why the red light comes on.

all depends on that amp... if there was an issue it wouldnt work, and the light would be by a protect symbol... if its just red next to the power symbol i say no issue.

There should be an amp input level control somewhere close to the rca inputs...does this have any effect?

double check your wires aren't shorting out or power or remote wires aren't grounding. check if speakers are blown with nine volt battery

that means that your amp is in protection mode, check all your wires and also the speaker configuration.

if its not coming on it usually means you have a bad ground if it works for a little while then does it then its over heating and you will need to get a fan