It seems to be a single wraparound piece with no screws?
On the right hand side of the handle there are 3 plastic plugs covering the screws that go through the anti-vibration bushings
Not helpful. Rubber plugs are held in by friction, not screws. Remove chain cover, take off chain and bar. Prise out 3 plugs that lock the rubber mountings. Remove trigger cover on handle, release spring and remove, pull off trigger and disconnect throttle link from trigger and throttle body. You may need to remove air filter box to get at throttle body. Now lever out the three rubber bushes from holes in metal body of saw, top first, rear second , front third. Turn and twist handle frame to release and remove. Replacement is the reverse procedure.
×
789 views
Usually answered in minutes!
×