I have a Samsung Smartv UN55J6201AF trying to connect my older receiver JVC RX-5030VBK can get sound through receiver! Could someone help me?

First of all, check if there is any audio device connected to the receiver. If there is, check if the audio device is turned on and the volume is correctly set.If the receiver does not have any audio device connected, then you should connect the antenna and try again.

Unless you are an electronics engineer, it is unlikely you can fix. Look on the back for a fuse holder. If there is check it with a multimeter. It may be protecting the audio parts. Make sure you don't have a button press for a different audio source than what you think and also check if you have switchable speaker outputs. Finally make sure the speakers are connected and the dog hasn't pulled them out.

Service Manual

https://www.audioservicemanuals.com/j/jvc/jvc-rx/261782-jvc-rx-817-vtn-service-manual

Strangely there are far more Service Manuals and no Owner Manual!!

https://www.google.com/search?q=JVC+RX+817+owner+manual

..

http://www.manualslib.com/download/83573/Jvc-Rx-5030vbk.html


Should be the right one.

Have you tried re-initiating it ? Strange the unit initiates but no sound.
Sorry, I forgot exactly how, but you can Google " factory reset
JVC RX-9010V". hope that helps.

no my antenna is a good one i tried with mp player too?? Is this a way to reset it to factory?

JVC has the manual for the RX-5030VBK (and RX-5030VSL) audio receiver here: resources.jvc.com/Resources/00/00/97/22026ien.pdf . You will need Adobe Reader or a similar program to read this manual.

I hope this helps.

Cindy Wells

For digital connections on your TV ( unknown model) read on page 7

[PDF] RX-6000VBK / RX-6008VBK INSTRUCTIONS AUDIO/VIDEO - JVC

Instructions from manual

This receiver is equipped with two DIGITAL IN terminals-one digital coaxial terminal and one digital optical terminal.
You can connect any component to one of the digital terminals using a digital coaxial cable (not supplied) or digital optical cable (not supplied).

IMPORTANT:
• When connecting a video component using the digital terminal, you also need to connect it to the video jack on the rear. Without connecting it to the video jack, you cannot view the playback picture.
• After connecting the components using the DIGITAL IN terminals, correctly set the following if necessary:
- Set the digital input (DIGITAL IN) terminal setting correctly. For details, see "Selecting the Digital Input Terminals-DIGITAL IN" on page 16.
- Select the digital input mode correctly. For details, see "Selecting the Analog or Digital Input Mode" on page 17

The rest can be found on the link below. NOTE the page numbers referrer to the manual pages NOT the pages numbers on the site.



JVC RX 5032VSL Instructions Manual Selecting The Analog Or Digital Input...

optical connection in tv is only input optical connection in receiver is only input will not work.need to connect rca jacks to tv's audio out jacks behind tv to any available input in receiver

Had same problem. A and B speakers are basically connected together, and there is no way to get the same volume out of each speaker. This is not a multi-source receiver like Onkyo. Zone 2 needs to go to a seperate amplifier and select teh correct source on the fornt,