Amana DW ADB1100AWW4 will run but Heavy, Hi Temp, Heated Dry and Start lights don't light. DW will Start but only on Normal (with light on)

SOURCE: Lights blinking and won't clear

the solution #3 should work.. you may want to try again.... first turn off the Breaker to cut power then wait a few minutes then turn back on, then within 6 seconds try (Heated dry)(normal)(heated dry)(normal).. all lights should light up then you know that you are in the service cycle, and the unit should go into a self test and clear the fault. The test take about 30 minutes. let me know if you can get into it...

SOURCE: Won't run - normal light flashes

You may try removing power to D/W for a minute and reconecting. likely cause though is keypad (console). If a light above a pad stays on the pad is likely closed all the time. Normal is probably cycle most often used. you can test the keypad by removing power to D/W and accessing the control panel. remove conncter P-1 and using an ohmeter test resistance between 13 and 4 on the connecter coming from keypad. yes without very small clips or 4 steady hands it is a little tricky. in the field we use a breakout board. if you get any reading when not pushed pad is bad. you may find a manual inside the kickplate which explains the keypad sequence. it may be control but more likely keypad, even if test is inconclusive.

SOURCE: Maytag MDBH950AWS Dishwasher won't start

We have a Maytag Dishwasher that won't start. The only button that lights up is the "Heavy Wash" cyle. When this button is pressed, the "Heated Dry", "Sanatize" and "Extra Rinse" lights up. The dishwasher doesn't start. Eventually all of the lights go out. the buttons start/cancel do not light up.could you in some way help?
Thank you.

SOURCE: Dishwasher: Green light flashes and will not turn on

Hi

Please press the following sequence to reset the washer "Heated dry" "Normal" Heated Dry" "Normal". This will reset the machine. Also try and locate the tech sheet in lower kickplate.

Please do accept this solution and revert for further assistance.

Thanks
Rylee

SOURCE: Maytag Quiet Series dishwasher won't start

Sounds like you have a bad Control Board

http://www.partstore.com/Part/Maytag/Maytag/MDB6600AWW/Maytag/Maytag/99003160/New.aspx

But with the price it cost, you might be better off buying a new dishwasher, preferably a different brand, cause that washer has some bad reviews