I have a Euro-Pro 8001 iron the gasket that goes around the cap where would I put water in has faded away need a replacement how do I purchase one

SOURCE: Manual for Euro-Pro G6118H

I don't know if you have the number for the euro pro customer service department; but, I had the same problem, called customer service, and had a manual emailed to me. The manual came within a couple of hours via email. In case you don't have the number and still need a manual for your unit, try calling 800.798.7398. I hope this helps and good luck!

SOURCE: shark euro-pro iron cord replacement model 4750

six screws on bottom plate two hidden under rubber feet on bottom under lower screw holes

SOURCE: euro-pro EP1005 iron--iron heats -blower works-but no steam

You may not need a new iron, my wife's iron is doing the same thing. take the top of the ironing board off (you will need a torx t-20 security bit driver), under the tank is a connection that may have rusted out re-connet it and turn the iron on. Once it heats up, check the tank for leaks. The tank may need to be replace as well or try a 5-minute epoxy type glue on the leaks once it has cooled. If the tank leaks you will get not get enlugh pressure building up to get the steam.

SOURCE: Euro-Pro Steam Generator G6200H iron

Hi,

Here is a tip that will help you to troubleshoot your iron and figure out what is wrong with it.

Electric Iron not Heating Up or not Working Right
http://www.fixya.com/support/r5300202-electric_iron_not_heating_up_or_not

heatman101

ernesto cuadra

• 12223 Answers
• Posted on Jul 23, 2012

SOURCE: REPLACEMENT COVER FOR EURO PRO IRONING BOARD -WEDGE

you must contact your supplier vendor of iron in order to get the parts. or search in internet by Marconny appliance.

God bless you