The lettering on my Bosch dishwasher has rubbed off. I haven't used it for awhile (kitchen Reno) now I don't remember the settings. It's model # 900359119 Rev.C. Thank you

In the instructions for different models of Bosch dishwashers, the e27 error is described as insufficient voltage in the electrical network. This means that if the mains voltage drops below 220V (or 110V in some countries), the dishwasher stops working, and the E27 error code appears.

Try going to a lot of new and used appliance stores and copying one like yours, or look at peoples dishwashers when you visit their house and copy their lettering.
God bless your efforts.

SHU5306UC-12 BOSCH DISHWASHER Manual - Sears ...

www.searspartsdirect.com > Kitchen Appliance Parts > Bosch Parts
Download Manual for Model SHU5306UC-12 BOSCH DISHWASHER.Sears PartsDirect has parts, manuals & part diagrams for all types of repair projects.

Clean Your Dishwasher with Tang (yep - the citrus drink)

1. Empty the dishwasher.
2. Run the water in the kitchen faucet until it is hot. (He suggests you do that before running your dishwasher every time.)
3. Turn the tap off and start the empty dishwasher.
4. After two or three minutes, stop the dishwasher and add a container of Tang.
5. Let it run the whole cycle.

Certainly could be a pinched wire in the door panel. I would remove the panel and see if anything is pinched or being interfered with like the rinse dispenser solenoid.

Dave

Hi

You can download the Bosch Dishwashers installation manual at this link. Just click on "Get this Manual"
http://kitchen.manualsonline.com/manuals/mfg/bosch/dishwasher_1.html

I have also included the actual users guide and operating manual for the SHE45 which is available here;
http://kitchen.manualsonline.com/manuals/mfg/bosch/she45m.html

Please allow time for the downloads to complete as they are large PDF files - then print or save to your computer as required.

Hope this helps. Please do rate my answer. Many Thanks.

I had the same problem and just today replaced the control board module. Purchased the control module online and installed in myself. Was not that difficult. undo the screws (torx screw driver needed) unhook the connections to the board and label all. Pull the board out and open, found burned connectors. Now works like a dream.

timer is ordering draining. or solenoid is on and it drains non stop.

Although I previously posted with the same problem of a film on the dishes after cleaning, I did find a section in the owner's manual which solved my problem. Lift up the rinse aid cap on the inside door - the factory setting is on "4". The rinse aid works in conjunction with your local water, which has variations in it's hardness or softness. When your dishes are streaky, lower the rinse aid setting to 1 or 2. If your dishes are spotted, raise the rinse aid setting higher.

I have a new Bosch dishwasher which smells up the whole kitchen when the door is opened (between washings). Someone should ban their sales.