I have a Bosch dishwasher exclusive Auto option. The dishwasher was swished off halfway through the cycle I rest it and it is stuck on the eco50 wash How do I make it work a gane

Try unplugging your dishwasher for 15 seconds or more, and then plug it back in. If that doesn't fix the problem, or if the problem comes back within a day, then you probably have a bad control board, or else the Auto key is stuck closed (like it is pressed).

It doesn't turn off at the end of the cycle because the cycle timer is stuck.

Try cutting electrical power to it for 5 minutes. That may set electronics

what is the model number

Wash Cycle Options

Delay Start (model dependent):

This option allows you to delay the start time of your dishwasher up

to 19 hours.

Sanitize:

The Sanitize feature is available only in the Heavy, Auto, Normal and Half Load cycles. Press the

"Sanitize Option" button to activate the Sanitation features during these cycles. The technical sanitation

measures may also improve the drying results. The sanitize LED or The "Water Pipe" symbol will light when sanitation

requirements are met.

Note: The dishwasher automatically defaults to Auto Wash when turned off and back on. If you used the sanitize option
in your last cycle, the dishwasher will default to Auto Wash with the Sanitize option selected when you turn it on.

To achieve proper drying, always use a liquid rinse aid, even if your detergent contains a rinse aid or

drying additive.

Note: The dishwasher indicates low rinse aid by turning on the Refill Rinse Aid indicator LED (for units without

a display) or The "Spray Looking" symbol (for units with a display).

If this light is on, you need to refill the rinse aid dispenser

I got the idea that the "squiggly arrow" has something to do with the sanitize feature also. If you post your model number "on the inside right hand side of your dishwasher door" I'll go get your manual and post the link here. Hope this helps so far! :)

Hi,
It obviously sounds like a timer issue here, and as it's embedded in a big chip on the control board, I would think a new control board is needed.
The exception to this is if it is not heating at all, in which case it won't advance if the water is not hot enough. Try it again and see if it gets warm.
If not - replace the heating element.
Most machines just stop to heat up the water, but to cut down cycle time they may recirculate the wash-water first to speed things up.

change the control module. im a old bosch tech. send me a 4thumbs post if this was helpful

This doesn't add up to what other owners say. Have yo contacted Bosch? Also, your output line may be entering your drain system in the wrong place causing the noise for that issue. Good luck. I am looking at the same machine for purchase......

press the rinse & hold/quick wash buttons at the same time until dishwasher begins to cycle then release. Dishwasher will run quickly through the rest of the cycles (without starting them) back to ground zero.

Hello zeviemail
Welcome

You said, your Bosch dishwasher on auto wash will stop functioning in middle of the cycle start beeping and there is an icon of a faucet on the display.


What is your model number and the year of the dishwasher?