Had the same problem. The display of the home cinema system kept showing "sony demo". I went to the system menu and reset all settings to factory!
Even if the system is off, the system consumes power to display the clock and to stay responsive to commands from the remote. The power saving mode is introduced to reduce the amount of power consumed during standby. In this mode, the clock is not displayed. To change to power saving mode, press DISPLAY on the remote repeatedly while the system is off until the demonstration and the clock display disappear. To change the display Press DISPLAY on the remote repeatedly while the system is off. Each time you press the button, the display changes cyclically as follows: Demonstration mode t Clock display* t Power saving mode * The clock is displayed only when you have set the clock. To cancel power saving mode Press DISPLAY on the remote repeatedly while the system is off until the demonstration or the clock display appears.
Hello,
please use the "display" button on the remote control. You can change between different modes, eg. power save or demo.
Harald
1,711 views
Usually answered in minutes!
Not only that but when you turn it off, there is a pause and then the demo starts running again! Any ideas out there?
Demo comes on when I turn the hi-fi off
×