Rangemaster part 2995 A119

I presume it is gas powered? They are available in all sorts of dual fuel variations. When you operate one element all the igniters spark. It sound like the igniter switch for the oven need adjusting. They normally operate on a cam so when you turn the control knob, the cam lobe runs up onto the micro-switch and then off it again creating a ignition spark on the way.

It is a gas appliance, so call for service.

Various other suggestions here

https://www.google.com/search?q=Rangemaster+Professional%2B+oven+igniter+keeps+clicking


..

possible control board

Turn off water main. remove round cap on face of handle, remove screw and pull handle. After that everything else can be pulled off easily. When you get to the diverter you should be able to why its stuck.

That happens either because the timer control is faulty, or because there is a contact on the element wires or connectors, and the element is grounded.

Control board and wiring harness are tested using a multimeter.

Enter the model number on one of two websites below to get parts and diagrams for your appliance:


Appliance Parts From PartSelect

Appliance Parts Pros

rangemaster do have parts for items they supply and a good help desk. find the number on the internet. sounds good what you think. but better to get the part. hey.

http://manualfox.com

I have downloaded the users guide from rangemaster.co.uk which has details of how to change parts & a wiring diagram, Hope this helps. Here is a section..............

5. To Remove Clock
Disconnect from electricity supply.
Remove the Control Panel (See 2). Pull off the timer
control button(s).
Remove the timer/mounting bracket assembly from the
control panel by removing the fi xing screws.
Remove the timer from its mounting bracket by
depressing the plastic lugs on the timer case, at the
same time pulling the unit forward.
Reassemble in reverse order. When replacing leads
refer to the wiring diagram. Check operation of timer.
BEFORE SERVICING ANY GAS CARRYING
COMPONENTS TURN OFF GAS SUPPLY.

This is a common problem, I repair these for Rangemaster so I suggets that you contact their customer service department they usually replace then for free

this noise probably means that the fan is about to stop working, this is what happened to mine. You can easily buy replacement fan off E-bay (it seems easier to find the right fan on e-bay that any of the confusing supplier sites). You then just need to remove the inside oven back and the outside electrical to replace the fan.

Comes on like this when switched on, hold down the left 2 buttons on the clock controls then whilst still holding them pres the right hand button

or manuals available here...
http://www.rangemaster.co.uk/index_Rangemaster_Manuals.htm