I have a nordic track a 2050 and when you go to push the speed up button it jumps to 1 mile an hour and then shuts off immediately what do you think is the problem

Question edited for clarity and correct name of maker.
Question moved from Tablets to maker category.

Contact Nordic Track with a view to returning it under warranty, or out of warranty repair.

https://www.google.com/search?q=Nordic+Track

..

ASK NORDIC WE ARE NOT THEIR SERVICE TECHS

The treadmill is set for kilometers, not miles.
With the stop button pressed, insert the safety key/magnet. This will display miles (or Kms) and hours of use.
There will also be a "M" for metric or "E" for english, or miles. Use the speed up/down buttons to adjust to "E".

check the key switch and adjust it

ensure that no setting has been changed to kilometers per hour.
there is about 1.6 miles to one Kilometer this might be the reason for showing slightly different.

check and reset to Miles.


I hope this was helpful

the motor controller needs replaced

Remove the console from the treadmill and remove the back
remove and replace the ribbon cables that run from the keypads to the control board (they are flat plastic strips that push into the board).
remove and replace all the connections on the console
reattach the console and calibrate by doing the following:
1. With the key off press the speed + and stop buttons at the same time and hold
2. place the key on and release the buttons
3. press the stop key once
4. press the speed up til it reaches 85
5. if your max speed is 10 mph then it should read about 9.8-10.2

If the keys will not work then the console is bad and would need replaced.

console is bad no other alternative, check ebay for part

go to iconservice.com click on manual input this info Nordic Track THEN Model name 2050 these 12 matches for that unit.

You should have a speed arrow up & down, this increases and decreases the speed in .1 mph. Try this control and see how the unit re-acts if the speed does not adjust in .1 mph increments or it stay the same either way it sounds like an upper board issue. Go to iconfitness.com go to customer service the replacement parts put you M# and will give part# and pricing.
RULE OF THUMB: IF REPAIR IS MORE THAN THE THE PURCHASE PRICE OF UNIT DOE NOT REPAIR