My mom said when she got into the bed she hit something on the remote and name we cant get the pick back. something about dta status keep showing please help

If you wish to get more; check the sites linked here. It has set-up code list & set-up procedure to many popular brand remote controls. One among it has general set-up codes to check with TVs and other devices are given, in the order of the 'device's brand name list' in alphabetical order. Pull up older posts. Search the sites by type in the brand name to your device in its search box at the top right part of the display window. It will help you to find the relative post easily.
http://remotesearch.blogspot.com/
http://electronicshelponline.blogspot.com/
http://electrohelponline.blogspot.com/

I needed to setup my Vizio TV's remote to control the Cisco DTA 170HD. I was able to get it working by using the Scientific Atlanta code 01877. Follow this link to read the user manual for the Vizio and there are more codes posted in there.

http://store.vizio.com/documents/downloads/hdtv/VU42LF/Manual.pdf

Hello, Kathi -

You may find the Tracfone speed dial instructions here helpful:
https://www.techwalla.com/articles/how-to-speed-dial-using-a-tracfone

Unsolicited advice from a "senior":
Eventually, you may wish to consider a Jitterbug phone for your mother. They are designed for seniors and have low cost monthly plans, much like Tracfone. See the Jitterbug cell phone information here:
https://www.greatcall.com/phones
Scroll down that page and click on the Compare Plans link.

There is no setup codes for GPX with Comcast DTA remote control.

Hello
Codes for Broksonic with Comcast DTA remote are :-10236, 10463. OK

Had same problem with my husbands moms bed. Found out that it ended up being a stripped plastic piece that the screw uses to raise and lower the bed. Because its stripped the screws don't have anything to grip on again to raise or lower bed. Piece needs replacing, but not sure where to get them.

i think kids playing with a remote for something else and they have found it works on your vehicle ,disconnect the battery before you go to bed then they will lose interest

You need to try to adjust it with the original remote in the TECH mode---you can save the adjustments there--

With the set on a video input with nothing connected:
hit the following buttons: 0 6 2 5 9 7 STATUS

The menu should appear with choices---green(do not adjust green) red to green, blue to green etc.

On that initial menu will be a item that says store or save. Depending on the remote you have once you select red to green (cursor on remote) a grid of lines should come up---on screen will be instruction--menu to adjust and or status to navigate.

When you have the red--to green adjusted hit the status button until it takes you back to the menu where Store or save is listed and right cursor on it.
This will store the adjustments.

Go back by selecting blue to green and adjust that also and when done go back and save it.

Turn the set off to exit the service mode and see what you have---IF THE SET DOES NOT RETAIN these adjustments made in the Tech menu something is wrong with its DCU--digital convergence unit---that stores the adjustments.


Let me know if you have questions as I am here to help people.

If this information helped you, rate this solution as I do this here for FREE.

SD TECH