SOURCE: NO POWER Fisher Paykel DD603 double drawer
sorry fab9 but this model doesnt have a float switch, it is also not possible to remove the rear panel!
If both drawer are dead, I supect either a mains cord issue or a problem with the RFI board (under lower drawer at rear). Possibly a bit tricky for a handyperson type repair, I suggest calling a servicman/women in!!
SOURCE: Fisher paykel DD603 top drawer starts cycle then
When it stops and beeps can you tell me all lights that are on when you open the drawer cheers. also check to see if the water in the tub is hot if not you have a heating issue. either a faulty element or Mtr Controller module. try swapping the Mtr Controller module (computer board) from the top drawer to the bottom drawer and see if that moves the fault. cheers
SOURCE: Fisher and Paykel DD603 top drawer jammed and will
Hey, I had this problem before!!!! Just unplug the unit off and wait about 10sec and plug it back on.....that usually does the trick.
SOURCE: Fisher Paykel DD603 Problem. Top drawer shows F1
Yup, definately the bottom drawer controller, for some reason you can run a DD603 with no board in the top, so long as you have a board in the bottom, but not the other way around. This is the fault you get, constant F1 from the top drawer. If you are stuck try removing the display cable from the bottom controller, this may help, so long as you leave the chassis harness in.
42 views
Usually answered in minutes!
×