How do I load tape in a Monarch PAXAR 1131? The machine was turned over to me, but the instruction manual is missing?

I haven't worked on Paxar products, but the manual directions seem reasonably complete, with drawings. (PDF pages 17-22 provide the basic directions; the following pages give directions for special media types and options.)


Error #756 = "Load Supplies"

I deduce from this that somehow you missed the paper detector when you loaded the supply strip. This is probably the "die cut sensor" referenced on page 2.3 (PDF page 19, shown in drawing on the next page). Make sure the strip feeds through the detector slot.

Here's a video that shows how to properly load supplies into the gun. It's possible that the supplies aren't loaded properly..

http://www.racoindustries.com/monarch-1130-1131-1136-labeler-loading-video.htm

Here's a video on how to properly load gun...

http://www.racoindustries.com/monarch-1130-1131-1136-labeler-loading-video.htm

You may wish to have Avery Dennison, the folks that purchased Monarch/Paxar, to service your printer.

Their phone number is 1-800-543-6650 and ask them the correct address for service. Your bands may be getting too loose, and need to be replaced. If it is something that they can instruct you to take care of, they can sell you the bands and provide instruction.

http://www.theretailerscatalog.com/howto.asp

Choose the 1115 operating instructions, and you should have the information you need.

Instead of me explaining how to do this, Avery Dennison, the folks that now own Monarch/Paxar, have a site where you can either read a PDF or use one of their videos -

http://www.theretailerscatalog.com/howto.asp

Instead of me explaining how to do this, Avery Dennison, the folks that now own Monarch/Paxar, have a site where you can either read a PDF or use one of their videos -

http://www.theretailerscatalog.com/howto.asp

http://www.theretailerscatalog.com/docs/1115oi_be.pdf
Here is a direct link to their operator instruction manual.

http://www.theretailerscatalog.com/howto.asp has a link to a video clip on how to do this.
I know that sometimes that written steps and documentation, though helpful to some, is not as helpful where video can step in. Towards the top of the page, there is a video link, click that. Then click on the 1130 link and you should have what you need.

How do you load lable roll into the Monarch paxar 1131?