What is output votage of logitech x230 system transformer ? I want to conect them to 12 v car batery directly ,so I need to know if it will be enough

Hey Jaime,
Unfortunately, Dell does not have any available schematics for wiring the x230 speakers available. You would have to maybe contact Logitech.
Thank You,
Dell-Jesse L
Dell Social Media and Communities

The two wires are meant to be connected to the 120 volt source. The box or the papers with the transformer should tell you which two of the three wires provides the 12 volt output. If not connect the two wires to the 120V source - Be CAREFUL! - 120V is dangerous. Then try, one at a time, touching each of the three combinations of wires (1&2, 1&3, 2&3) to the contacts on a 12 V incandescent lamp (very bottom and threaded side) the 12V pair will give you the brightest light. The other two are 6v.

I can't address the 7 blade connector without more information. I suggest that you go to a place that sells trailer parts.

Not knowing anything about your trailer I don't know if a 2 amp (2000 ma) transformer will supply enough current to do the job.

Nominal Output Power (Total) -- 2.3 Watt


On the back of the right speaker where the power cable is connected there is a sticker where you can see the voltage the speakers are using. You should read there 120 V - 60 Hz 100mA.

You will have to use a voltage adapter from 120v to 220v. (found in electronic shops) that maintains the Voltage stability.


Regards,
Tariq Khan

Might need an install the cd for it...shouldn't be that hard.

If the DC is 15v then the AC is around 12v.

ok sounds like you have a dead battery
1) if turns but slowly:

posible causes:
1.1) old dead batery/
or underchaged battery >check altenator in this case

did you leave your headlights turnt on and drained the battery of its charge?if so get a jump start and then run the car for 30-45 mins to rechagre the battery

if you have at your disposal anothere batery that you know has a good charge
try starting your car with that batery(not using jumper cables) hook it up!
if the slugish turn over is still there

1.2) check your wire conections for corision this means completly disconecting 1 lead at a time (only on one end of that lead)and cleaning them with a wire brush or some sand paper.
(on the battery and the starter also the ground strap conection to the frame.)

2) WONT TURN OVER AT ALL:
posible causes:
2.0) dead battery >try charging it>get a jump start
2.1) blown turnkey igntion fuse
2.2) blow fuse for main har nes wires
2.3) bad starter
2.4) corosion on wire conection (most often the batery terminals)
2.5) starter replaced and hooked up incorectly.

2.6) alram system preventing the turnkey igntion system from getting power

Plug the green lead on the speakers into the headphone socket on the television. You may need to go into the menu to turn up the headphone output. Turn it to 70% on the TV, then use the volume control on the speakers

Visit this kink: http://www.new-drivers.com/files/speakers/Logitech/?gclid=CM_a2oOjtpkCFcQtpAod6hp-5Q and download the latest driver for free....sodeep

i did the same to mine,

just replace the power transformer with one that accepts 110-240 volts

easy to do, but check cost might be better to buy a new set depends on your situation

Reinstall sound card drivers.