IBM ThinkPad T40 2373 Notebook Logo

Related Topics:

m
marilyn mansur Posted on Nov 06, 2016

I have a iBM t40 2373 Thinkpad note pad when i turn it on i get 2 codes one is 0176 and the other is 0271 how do i fix it

5 Related Answers

Anonymous

  • 558 Answers
  • Posted on Sep 17, 2008

SOURCE: i forgot my bios password

Hi Marbz,

Read this article may be helpful to you

http://www.dewassoc.com/support/bios/bios_password.htm

And not to forget rating me.


Regards
ELLIN

Ad

Anonymous

  • 20 Answers
  • Posted on Oct 10, 2008

SOURCE: IBM ThinkPad 600E 2645 PC

the following data is from the hardware maintenance manual for the thinkpad 600 series and is readily available from http://www.lenovo.com/support


Symptom or error FRU or action, in
sequence
161
Dead battery.
1. Go to “Checking the
backup battery” on
page 12.
2. Backup battery.
3. System board.
163
Time and date were not set.
1. Set time and date.
2. System board.
173
Configuration data was lost.
1. Select OK in the error
screen; then set the
time and date.
2. Backup battery.
3. System board.
192
Fan error.
1. Go to “Testing the
computer” on
page 7.
2. Measure the voltage of
the backup battery. If
the voltage is not
correct, replace the
backup battery.
3. Fan.
4. System board.

Anonymous

  • 2712 Answers
  • Posted on Oct 25, 2008

SOURCE: IBM THINKPAD T30 KEYBOARD

Make sure NumLock is OFF.

Anonymous

  • 748 Answers
  • Posted on Mar 25, 2009

SOURCE: How do I get pass IBM Thinkpad A31 Lock Code?

Laptop BIOS passwords are kept in a special password chip. On some laptops these chips are replaceable and there are a number of places you can buy this. PWcrack.com for one.

Anonymous

  • 32281 Answers
  • Posted on Mar 30, 2009

SOURCE: ibm think pad r51 nodisplay 4 beeps commaing

This indicates a possible memory problem. Reseat the RAM modules and boot up, if OK then the laptop is OK.
If not then :-
If you have two RAM modules, remove both and insert one and boot up, if it is OK then repeat with the other one - this will determine which memory module is faulty.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Touchpad not working ibm thinkpad

ibm think pad T43 is bess loptop for student
1helpful
2answers

My thinkpad t61p is not booting/no video. Giving 3 beeps, 1 long and 2 short beeps.

Hello
1 long, 2 short is an error with the video adapter. This isn't specific to IBM systems either, that code is the same for pretty much every BIOS out there.
It seems your video card may be at fault. has anything changed? do you have any picture on the display at all? If you have zero picture it will be hard to get into safe mode and try to roll back drivers etc. It may be that the video adapter is just defective. You can contact IBM/Lenova and see about getting a replacment or you can take it into an authorized repair place. You can also attempt to obtain a replacement video adapter for the T61 and install it yoursel fif you have the knowhow
Hope this helps Good luck!
0helpful
1answer
0helpful
1answer

Laptop mouse problem

This is a common problem with laptops, unfortunately, there is no real solution of fixing the touch pad.
The best solution is to use an external usb mouse.
I recomend an optical mouse, they cost about 5 US dollars.
5helpful
1answer

How do I turn on the wireless on an IBM ThinkPad 2628 A20m Thanks in advance

Hi,

To turn on the wireless on IBM Think Pad 2628 A20m you can try the below options

IBM
IBM General - Some models have the wireless slide button on the side of the laptop.
IBM DV series - use the antenna-like button found on the upper section of your keyboard.
IBM R40 - Use the Fn+F5 key-combo.
IBM Thinkpad (General) - Most have software switch or button on Left hand side.
IBM Thinkpad (model not further identified) wireless switch on Front edge of case.
IBM T43/X32 - Fn+F5 -Click "Turn On"
IBM ZD series use the antenna-like button just below the “Lock” key.
Let me know fi this will help
1helpful
1answer

Problem with ibm thinkpad r40

The IBM beep code error 1 long 2 short beeps means there is a video card fault. Reseat your RAM because the video card uses some of the RAM. If it doesn't work then the video chip on the motherboard is faulty, the only way to fix is to replace the motherboard - this may not be a cost effective solution.
Connecting an external monitor to the laptop won't work because the video card also sends data to the video port.
0helpful
1answer
1helpful
2answers
Not finding what you are looking for?

95 views

Ask a Question

Usually answered in minutes!

Top IBM Computers & Internet Experts

Brad Brown

Level 3 Expert

19187 Answers

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

ExpressFiX
ExpressFiX

Level 2 Expert

691 Answers

Are you an IBM Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...