I have a Go-Go & Pride Travel Mobility Scooters and get a Speed Pot error. Where do I buy a Speed Pot with Harness for Go-Go & Pride Travel Mobility Scooters in Canada?

mechanic is the solution

It's more likely to be the speed control potentiometer (pot) that is giving you trouble, they quite often go wrong. Replacements are easily found on eBay and are not expensive - but be sure to buy the correct one... and carefully note the cables and terminals used BEFORE you remove the old one.

hi, can i ask you what the pot was like , a electronic one or mechanical one ?

If it's Electronic check there is a 24v - + plus voltage on the red and black cable. This is a common problem with these scooters.

regards
www.gewizrepairs.co.uk

Pride scooters are known for this problem, as I found out when it happened to mine.

You need to replace the Throttle Pot. Either take it to a mobility shop and let them do it or buy the part and do it yourself. It simply involves unscrewing the old one and screwing the new one into place, and there are diagrams to help you on the internet.

This throttle pot problem has happened to my Pride scooter three times already.

sufi you will need to replace the speed control pot. Contact Pride @1-800-800-8586 ask for scooter tech support and explain your problem and ask about ordering a new pot hope this helps

csr4 Well it could be the throttle pot or the speed control pot My leanings is toward the throttle pot since it works in reverse with the speed pot not being changed but not forward. when you are just changing the position of the throttle to forward thereby changing the pot wiper and getting the error. Contact Pride about the problem at 1-800-800-8586 and ask for Tech support for scooters and explain your problem to them. I hope this helps

I would say to change the pot,its the variable contacts on the high end of the speed pot that is worn out not making contact.

Hi. A faulty speed control pot ( wig wag ) will cause this problem.
While you are driving along on a smooth surface, move the end of the lever carefully up and down, not in and out as you normally do. Doing this will help to see if there is a problem with the pot, it will cause the speed to vary or change.
Can sometimes be caused by stuck or worn motor brushes.
Good luck. Neil.

You will more than likely need a new speed pot but some are connected to the throttle pot as well so it could be that which is at fault. Could also be wiring or worst case, control box but this is unlikely.

If the battery is charged fully, check the speed knob on the steering console. It is probably turned too low.