How do I wind a bobbin?

If the needle on your Singer Quilter Confidence machine moves when you're winding the bobbin, it's likely due to a few possible reasons. Here are some steps you can take to resolve this issue:

1. Check the threading: Make sure the thread is properly threaded through the machine, as an incorrect threading can cause the needle to move during bobbin winding.
2. Tighten the needle clamp screw: If the needle clamp screw is loose, it can cause the needle to vibrate during bobbin winding. To tighten the screw, use a screwdriver to turn the screw clockwise.
3. Check the bobbin winder tension: If the bobbin winder tension is too loose, it can cause the needle to move. To adjust the tension, refer to the manual for your Singer Quilter Confidence machine.
4. Check for any obstructions: Make sure there are no obstructions near the needle, such as thread tails, fabric, or lint, as these can cause the needle to move during bobbin winding.

If you've tried all of these steps and the needle continues to move during bobbin winding, it may be a mechanical issue that requires a professional to fix. I would recommend contacting Singer for further assistance.

Hi, Quite often with Brother machines there is no left/center/right needle position control but rather when the machine is set to sew straight the Stitch Width control will determine the needle positon.
While sewing straight try changing the Width(zig zag) control.
It is possible that it will only move from center to right.
Bob

Google your brand of sewing machine, manufacturers will have instructions on their website, under support, then type in modle number.

hi ina.
see if this link helps you out.
bobbin winding shaft isn gripping the bobbin Google Search

Are you using the bobbin especially designed for that function? Did you use the plastic template? Setting up for endless bobbin winding is quite involved, and it's easy to skip a step and make a mistake. It took me several tries to set mine up.. Frankly, once I finally got it set up, I wasn't thrilled. It doesn't hold a lot of thread, and it was quite frequently interrupting the project to wind more thread on the bobbin.

I always use my finger to guide the thread as the bobbin is winding,the bobbin shouldn't be moving around in the metalcase probably needs tightened.

slide the bobbin wind wheel away from the main wheel.

Visit us at www.ifixmachine.com to avail for a new manual for only $10.00

How do I wet wind a 2 inchs long bobbin using varnish.

Thanks
Gholam