Dimensions of chef wall oven

See the installation instructions, page 9. https://mcappliance.com/media/manuals/MCSWOE24S.pdf

You could try the Electrolux (Chef) sales division on the Australian phone number: 1300 363 601

To need but for get a dictionary? Help Me Find My Model Number

when you buy the ovens replacement
instructions are given in the paper work how to adjust the cavity to suit

there will have to be an air gap on back and sides of the new oven

you should call an electrician to wire in the new oven
to check , even replace the 1987 wiring and connections
if needed to meet the 2016 house wiring standards

you will need
tape measure
pencils
a square
straight edge
reversible hand drill and bits
two levels .... for inside the cavity to level oven
approx a 15 inch .one 6 inch
a hand saw or circular saw
, i found a jigsaw helpful

self tapping screws different lengths
as per the oven fitting requirements
you can use any paint to finish the job

white board or MDF board is ok

some extras strips of timber to level the new oven
maybe required

if imperial was used for the cavity of the old oven
metric might be for the new oven

some DIY about wall oven installs are found on youtube

The bake element has gone bad. They can visually look fine but still be bad. To check and replace that element you will unfortunately need to kill the power and remove it from the wall. Remove the back cover. Check for a low resistance (around 16 ohms) across the bake element. If the resistance is high the element is bad. Google the make and model for a replacement element.

The F3 code means that the temperature sensor in the oven is not giving the signal to the oven control. This could be the result of a problem with the wiring or the wire harness between the control board and the sensor or indicate that the sensor itself has failed.

To identify the correct parts, you need to provide your oven model number. Try here: http://www.partselect.com/Magic-Chef-Parts.htm . There are other sources for parts.

I hope this helps. If you add a comment with the model number, I'll be glad to give you more specific information for your wall oven.

Cindy Wells

Keefe Merritt 12 6267 Manual Book

O & M was merged with what has become Frigidaire/Electrolux Home Products.

You can get parts from them.

The serial number for a built in wall oven from that era would be something like this : 11-6361-30/123

Electrolux's parts number is 800 599 7569. (Phone number)

If the oven needs replacing, Sears, Magic Chef, and Whirlpool offer something in this size range. (You need to measure the dimensions.)

You may need to "google" "O'Keefe & Merritt electric oven repair" plus your location. Electrolux's service department might provide a contact.