Hotpoint Aquarius wd640 has test on the led display, will not fill or empty but goes through the cycle.

SOURCE: Hotpoint Aquarius WD640 Washer Dryer

I had a similar experience.  I had to try a few times - it has to be EXACTLY together and then the magic "doff" shall appear and save the world.

SOURCE: Aquarius Hotpoint WD640 is not spinning

pump problems

Barry Coates

• 3463 Answers
• Posted on Jan 25, 2009

SOURCE: I have a hotpoint aquarius

Most washers made today, are cold fill only, best way to check is look at rear of washer, and if there is only one hose, then it is cold fill only, if 2 hoses, then hot and cold fill..
So if your boiler is not working, then it should be o/k to use if cold fill only.
Plz rate my solution.
Thanks.

Barry Coates

• 3463 Answers
• Posted on Feb 08, 2009

SOURCE: hotpoint washing machine Aquarius WD640

Try this sequence; Hold down start and cancel button together, TEST should disappear of display,
Then hold down START/ CANCEL, and ON/OFF at the same time.
The message D/off should appear in the display, it should then work.
If it does not then the main pcb is likely to be faulty..
That will mean calling an engineer.
Pleas rate my fixya solution.
Thankyou.

SOURCE: Hopoint aquarius wd640 will not dry

check heater for drying programe