Go Go Ultra X Scooter is randomly beeping while in use. The scooter seems to be working fine, so I don't think beep codes would apply. It just beeps 1-4 times at random while we are using it.

hi Janeen , to assist you any further i first need to know the Brand and model of scooter ?

Regards
Rob

5 beeps usually means scooter is out of gear, but since the lever is in the drive position and the scooter gearbox/differential is engaged, it seems that the controller is not sensing the gear change. Possibly a faulty micro switch in the motor housing can be the cause of this, usually the micro switch is pressed down by the drive lever and if the switch is pressed down the motor controller knows the scooter is in gear.

2 beeps=too low battery voltage
3 beeps=battery voltage too high
5 beeps=solenoid brake trip or free wheel mode
remove key then push then push the manual release lever in completely
6 beeps=throttle trip
throttle control lever may have been depressed while
inserting key so release control lever completely
7 beeps=throttle trip
throttle potentiometer fault or speed potentiometer fault

9-beep. Major controller error. Check all wiring, remove battteries for 10 seconds and try again. If still 9-beeps you need a new controller - which is pricy and rearely worth replacing.

sounds to me like the starter solenoid that's what I would replce first , then look towards new battery's if that fails .

Hi, when it stops and starts bleeping , Do you turn it off and start again or does it just go again ?,,,

Regards
Rob

www.gewizrepairs.co.uk

This scooter has an S drive controller. The beep code will begin with 10 very fast beeps followed by a number of slower beeps. The number of slower beeps indicates the actual code. It will do this only once. To repeat the beep code, remove and reinsert the key.
Beep code #9 is a possible controller trip.
Diagnosis:
The key may have been inserted during battery box installation.
The controller may be overheated.
The brake is dragging or pulling too much current.
Solution:
Remove the key from the key switch before installing the battery box.
If the problem persists shut down the scooter for 10-15 minutes and allow the controller to cool down.
Bottom line is that you may need a new controller or brake. Keep in mind these may be warranty items. A qualified technician may be needed to diagnose and repair the problem. Hope this helps.

Make sure that the scooter is not in freewheel (the freewheel lever at the rear of the chair needs to be in drive position) If you can push the scooter easily then its in freewheel mode If you have the owners manual check to see if they have the beeps codes listed and look for the code you aare getting if you don't have the manual try the manufacturers website to download one Hope this helps

How many times does it beep or is it continuous? Should beep a few times (usually up to 9 times), then stop, then beep so many times again, then stop and so an and so forth. Most of the time this is caused by the scooter being in freewheel or THINKING its in freewheel which could be a faulty brake switch. Also, on the GoGo ultra, the battery contacts regularly cause this problem and have to be replaced. They should be splotlessly clean and shiny for the contact to be good.