Robot coupe food processor RC2800 SN: R2579592 120v 6amp has no power at all, and power supply is good

Question moved to correct category.

Page 17 onwards has the wiring diagrams

https://www.webstaurantstore.com/documents/pdf/r502_r602_-_manual.pdf

..

Hi im after a replacement lid for my robot chef rc3 if anyone has a spair one please email me at [email protected]

Thanks so much for the advice. Any idea what size TORX is required?

You may be able to get it here:

http://www.nisbets.ie/products/AdvancedSearch.asp?keyword=cl30&x=64&y=5&PageSize=50

The part isn't listed but if you ring them they might be able to order it in.

To the person wanting a funnel for her robot chef just bought an old processor on eBay to replace the bowl I've got the lid if you still need it

It just a long shaft phillips screwdriver. The screws are located under the foot pads. They just pull out and then there are the four screws.

Robot-Coupe USA.com should be able to sell you anything needed

There is a reed swich (safety switch) located on the top where the lid comes down. A reed switch works with a magnet. If the magnet is missing or the reed swictch is bad, no power will be allowed to the motor. Send me your e-mail & I will look up the part # in my Robot-Coupe manual. [email protected]

Cindy,
Send me your e-mail & I will send you back an exploded view of your Robot-Coupe. It will give all the info needed. [email protected]

3BX9k4 PLEASE DESCRIBE IN BRIEF WHAT THE PROBLEM IS?