Question about Lanier Office Equipment & Supplies
Heres a good try...works 90% of the time....unplug machine for 10 mins and restart...hopfully this will clear the error...GL my friend
Posted on Aug 13, 2016
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
You will need to replace the main drive motor assembly.
That stepper motor is a common fail item.
You have to remove the rear cover, the MFSYS and MCU board assembly to access that motor.
Posted on Jul 09, 2008
hello Sir; You have to empty the waste toner bottle it located right hand side bottom, open the doorlook at "A" area you will see a big narrow plastic bottle pull out a black buckle slide out the bottle, dump the toner,the code will be disappear!
Posted on Jan 06, 2009
SOURCE: RICHO AFICIO 650 SHOW ERROR 890
The code 890 do not exist like 880 but, if it is 980? the problem can be in the hard disc...
Incorrect parameter sent to the HDD controller.
First try reset the software… press the point and numeral key simultaneously until automatically it is off the copier, several seconds can pass, the copier back on automatically. The software will have been loaded again.
If the problem persists it proves with another hard disk,
since the other possible solutions already are more complicated; these are:
· Software defective
· SBICU defective
Another problem that sometimes cause erratic errors in these copiers is that it has fallen develop in some sensor having caused short circuits that annul to some times some voltage of the power supply interrupting processes indispensable for software. Example “by developer in the ID sensor” the copier scanned but nothing more. Developer in the sensors of the feeding units produced a code 322 can seem incredible but it is thus.
For it would recommend a deep cleaning of the sectors of the image unit and everything what is under the development unit.
Posted on Sep 02, 2009
SOURCE: Aficio 551 - error code SC124
No encoder signal from the scanner motor
• Scanner motor connector defective
• Scanner motor defective
• MCU defective
• Scanner wire, timing belt, pulley out of position
• PSU defective
The screws of the pulley usually are cut that moves the scanner this causes that the car is crossed and that the sensor does not detect the home position. check and corect this defect.
Posted on Sep 13, 2009
Tips for a great answer:
Jan 17, 2013 | Canon PIXMA MG2120 Photo All-in-One Inkjet...
Dec 11, 2011 | Lexmark X7170 All-In-One Scan/Copy/Fax and...
Dec 24, 2010 | Canon (6981A002AA) for imagerunner 2200,...
Jan 20, 2010 | Lexmark X7170 All-In-One Scan/Copy/Fax and...
Jan 16, 2010 | Canon imageRUNNER 3300 All-In-One Laser...
Nov 03, 2009 | Dell 962 Photo All-In-One InkJet Printer
Jan 06, 2009 | Ricoh Aficio 450 Copier
Nov 20, 2008 | Lexmark X7170 All-In-One Scan/Copy/Fax and...
Oct 29, 2008 | Office Equipment & Supplies
30 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: