My top drawer of kitchenaid dishwasher lock light is on. I can't get it off?

If you using upper or lower drawer and this shows up it means the dishwasher has water under the filter board which located on the bottom under the lower drawer. You have to disconnected power,removed the lower drawer, clean the water, replaced filter board, check the dishwasher for leaking.

I’m happy to help further over the phone at https://www.6ya.com/expert/vitaliy_f406165329c75ede

How to Clean a Kitchenaid Dishwasher Filter

Read more : http://www.ehow.com/how_4826080_clean-kitchenaid-dishwasher-filter.html

look under the sink for the valve its huge an inline with the waste tube
if not then its here
https://www.youtube.com/watch?v=rOio5HaWeFU

The upper rack has a captive washer with a lug that stops the top drawer from falling out. Use a torch, identify the captive washer that is connected to the rear wheel on each side if the drawer, remove these and the draw will come out

The lock lever on the unit --- that is shaped like a U --- if you have it ---may be bent a little. You can move it to the correct position - usually down a little --and your door will stay closed

Mine does the same thing! (Same model) I've finally discovered that if I start the bottom drawer first and the top drawer just after that doesn't happen as much. Also, if I run the garbage disposal (and water obviously) while it's starting (I will try to do my hand washing while the dishwasher is getting going) that seems to keep this from happening as well. I've given up running just one drawer, which totally defeats the purpose of buying the 2 drawer dishwasher. But it does keep me from having to bail the bottom drawer :-( I'd like a better solution to this too!

On the right side of each drawer, near the top is an optical sensor (light pipe) that reflects infrared light of the side panel to indicate proper door closure. I f the unit is not aligned/installed properly the sensor will not sense proper door closure.

you have to push the pro cycle for about 10 seconds and that will cancel lock message.

switch it of and leave for say 10mins and switch back on and see if it resets,if not push and hold the on/off button for about 30 secounds it should reset if not then the drawer switch is broken and needs replaced.adrian,,,,,,

1. Locate the "Energy Saver/Dry" button on the dishwasher. The location of this button will be different depending upon the specific model number of the dishwasher, but should be easy to spot. If you have trouble finding it, you can check the diagram in the manual of your dishwasher for the exact location for your specific model.

2. Press and hold down this "Energy Saver/Dry" button for at least four seconds. Make sure that you do not release the button until at least 4 seconds have passed, otherwise the lock will not become disabled.

3. Check to make sure that the child lock indicator light has turned off. If this light is no longer on, this means you were successful at turning off the child lock. If the light is still on, repeat the process, but try to press and hold the "Energy Saver/Dry" button for a few seconds longer. If it still doesn't work, there may be a more complicated issue with your dishwasher. Consult your manual, or call to the manufacturer or repair man to determine if there is another problem with your dishwasher.