Reset flashing . Won't light - Dayton Gas Furnace Heater

Question edited for clarity and toss in some CAPS.

Reset it. There has been a power loss. It appears to be a known issue.

https://www.google.com/search?q=Chef%27s+Mark+Crock+Pot.+The+Off+light+flashes+and+won%27t+turn+on

You will have to reset the dishwasher. First try and turn off the mains power and back on after a short time. If the clean light flashing starts again then you go through the hard reset procedure.

press NORMAL WASH then HEATED DRY buttons one after the other until all the lights on the board lit up (3X's). The dishwasher will enter into a cycle; Press Cancel. This should stop the flashing.
If you are supplying dishwasher from hot water inlet then make sure the inlet water temperature stays within the recommended range of 145 deg F.

Call company ASAP..
and they may give you a new one..
after my research.. many have a lot of troubles,
some are different than yours.
or call 1-800 555 1212.. for company information
to call company..
Bummer not having Coffee when you want it.

push and hold the power button, i did yhat to mine and it now works,also if it comes on reset the tv

Turn the ignition key to on position, but do not start the vehicle.
Wait for the "change oil light" to come on
Tap the throttle pedal three times quickly
Wait for the light to flash several times, then go out.
Start the car and drive and it won't come back on.

It usually works the first time, but repeat if light stays on.

the green light blinking is normal if set has been unplugged--when set is plugged back it should blink for about 70 seconds and then go out--then you can try to turn it on---it is the DM unit inside the set booting up.

If the light just blinks and never stops you have likely bad caps in the DM unit---there are kits available for that.

The other possible reason is that so called reset switch may be bad--fairly easy way to find that out and it is more common than you would think, let me know if you have questions.

SD TECH

Try a factory reset

Are there any lights lit on the front of the TV? Have you checked for a bad lamp? When you reset the TV the timer/power light should flash on and off rapidly for 60-70 sseconds. Does that happen?

Go to your local O'Rielly's or Autozone. They will tell you the code and reset it for free. Otherwise take the negative battery cable loose for about 10 min. This will clear the ECM, but you won't know what tripped the light! Best Wishes, TJ

Some cars can be reset by turning the ignition to on and waiting a while to reset. Could be as much as 10 minutes. The light will stop flashing when it is reset. Others have a different process. If you have the owners manual it may tell how to do this.

This may work also and a lot faster.
insert the key in
the drivers door, turn left, then right
to disarm and reset it.