BSA S type air gun. How can I remove spring? - BSA Optics

Antique Air Guns for Sale GunStar try looking on this site might help you out

The coating that BSA used on their scopes reacts badly with certain airborne oils and softens rubs off and looks scabby
Only thing to do is to rub the rest of the coating off with high acetone nail polish remover

With magazine out, what happens after cocking, should get a gush of air, if nothing, spring not latching, or seal leaking badly, have you adjusted trigger, to fine with a spring type, will not latch, so no pressure, can you feel anything happening, nothing at all spring latch, can you feel the pressure of the spring when you cook it.

How to put the trigger on the bsa meteor 22cal spring gun

how to fix crosman rifle scope?

Give BSA a call at: 01494 676740 If you're not in GB, it's an overseas call.

I know it's a dumb question (maybe), but are you sure the bolt is fully advanced and locked and the safety's off?

I contacted BSA and they e-mailed me the instructions!

The barrel pushes the piston back when you **** it.

The seer grabs the piston to hold it.

It sounds like you have an engagement issue between your seer and piston.

Often there are springs which hold the triger paul and seers in place. You may have lost a spring which isnt allowing your trigger mechanism to reset after the trigger is pulled. This results in the trigger being permanitly in the fired position.

Good luck and hope this gives you something to look for

Go to a Crosman service parts vendor such as http://www.scopesandammo.com who are in Canada