I want to register DW325Pl nailer - Dewalt Electrical Supplies

look on the unit the receipt or the box- theres not another way to find it if you did not write it down or register it.
good luck
https://www.6ya.com/mrmmike

Go to this site to register your nailer
Register Product

Bostitch nailers used three methods to adjust how deep the nail will set. On stick nailer, there are one or two screws on the lower contact arm allows you to shift up or down. On coil nailers and others , there is thumb screw on side or under the trigger. Finally on some coil nailers, there was a series of spacers that snapped onto nose of the gun. Good luck

Hello tcw. Right now you can get a new one at amazon.com for about $277. here is the link http://www.amazon.com/Porta-Nailer-403-Hardwood-Flooring-Nailer/dp/B00030MM6C

Joe

There are usually two gages, one for the pressure in the tank, the other is for the regulated pressure in the hose going to whatever tool you have connected. I assume the tank filled up and the tank gage registers pressure in the tank. When you said you "opened the gage" I am guessing that you turned the knob counter-clockwise which would be the normal direction to open a valve. However, this is not a valve, it is a spring loaded regulator device. When you turn the knob counterclockwise you are removing all pressure from the spring which sets the regulator to allow zero pressure in the hose. Turn the knob clockwise to increase the pressure in the hose. I hope this was helpful. Good luck.

Hi,

Bad o-rings or bent firing pin...

Here is a tip that I wrote about the Paslode nailers and the problems that can come up with them.

I also have a link to the Paslode manuals which contain Paslode cleaning and troubleshooting guides.

If you need parts for your Paslode, there also is a link for a site that sells the Paslode nailer parts.

Paslode Cordless Nailer Problems

heatman101

Hi,

Here is a tip that I wrote about the Paslode nailers and the problems that can come up with them.

I also have a link to the Paslode manuals which contain Paslode cleaning and troubleshooting guides.

If you need parts for your Paslode, there also is a link for a site that sells the Paslode nailer parts.

Paslode Cordless Nailer Problems

heatman101

-][][

Take 4 bolts off of head . Clean and lube head valve with air nailer oil. Not wd40

Soory It is a roofing nailer not a Paslode framing nailer. ended up replacing the main valve. all is well now. thanks