I turn car on cranks fine no throttle /acceleration gas pedal goes to floor no response in park drive neutral or reverse . ESP sensor is on I have tried to push button and disconnect battery.

Connecting a pro grade scan tool computer will tell you the DTC Code and that tells you what the problem is and how to fix it. The 'Wrench Light', properly the 'Engine Malfunction Light' is there to tell you that you have a problem and the scan tool tells you what it is?

What is the car? This sounds like it could be a throttle position sensor, (TPS). This monitors how hard you are pressing the gas pedal and if it is faulty it won't be reading the pedal movement correctly. Other symptoms are uneven idle and the acceleration isn't smooth or even.

• WHAT KIND OF CAR OR TRUCK IS IT

linkage cable only changes ratio selections
if it is faulty , it will be stuck in one gear
the reason it is not accelerating is because the accelerator pedal and the throttle control are not communicating with each other
run the fault codes to check which sensor is faulty or if any other sensor is responsible

I would check a few things. first the engine mounts. make sure the engine isn't rocking over. second cruise control ? if it has cruise control I would unhook the cable to the throttle from the cruise control and see if that was the issue. some times the control box will pull in deceleration mode and stick there. also the decelerator valve on the throttle body may be defective.

dirty throttle body, check air filter.

throttle position sensor is bad

P0700

The transmission of a vehicle which has suffered a transmission problem will send the P0700 code to the vehicle engine control module (ECM)

P0705 Transmission Range Sensor Circuit Malfunction

Possible causes

- Open or short park/neutral position switch circuit
- Poor park/neutral position switch circuit connection
- Misadjusted park/neutral position switch
- Park/neutral position switch may be faulty

P0455. A code p0455 most likely means one or more of the following has happened:

A loose or improperly affixed gas cap

A non-conforming gas cap (i.e. not factory/original brand)

Other leak or damaged piece in EVAP system

P1125 Accelerator Pedal Position (APP) System

P2125 Throttle/Pedal Position Sensor/Switch "E" Circuit

P2138 Throttle possition sensor

check throttle position sensor wire chewed up, broken wire or unplugged? check with volt meter mesure the voltage @ throttle positon sensor see if there's voltage goes up/down when u apply/release gas.