Reset model smu7052uc

Reset the dishwasher by pressing and holding the "Start" button for at least three seconds. Depending upon the Bosch dishwasher model you have, you also can push the "Cancel-Reset" button to reset the dishwasher. Select a new cycle and press "Start."

o reset the control module AP2802870, you will put the dishwasher into the cancel/drain mode and let it complete the cycle. When you installed the new control remove the jumper from the original front lower right hand # 1 board male port. Starting from the extreme lower rt.corner, there is a 6-terminal connector with a jumper wire looping # 5 and # 6 terminals. (counting from the right to the left). Use this on your new board. Then reset the controls.

You seem to have inadvertently put it into the test sequence. Try pressing the two reset button simultaneously (usually the reset buttons are 1st and 3rd from left each with a dot underneath, if this does not work, press the button between the two resets (2nd button) P1 should come on then press the right reset button. The unit should run through a test cycle for approx 20mins and eventually reset the module, this is indicated by 0 in the display. Please repost if further assistance required.

Dear Sir:
Please follow the step in your instruction manual for to reset.
if you do not have the instruction m go for free download:

www. fitness.manualsonline.com or www. retrevo.com

anyway go to this page and see for reference:
http://www.ehow.com/how_4899022_reset-bosch-dishwasher.html

sincerely.

major recall of bosch dishwashers. recommend you check the list. https://www.consumerreports.org/dishwashers/maker-bosch-expands-dishwasher-recall/

I have a 10 year old Bosch SMU 7000 and the drying function has ceased. Dishes are wet after all cycles. From what Ive read this isn't worth fixing because Bosch are so difficult to get into.

press cancel/drain sequence to get water out-check owners manual.
2 possible solutions to your problem discussed here:
http://www.squidoo.com/Bosch_Dishwasher_Drainage_Problem_Fixes
problem may be a burnt out solder connection on circuit board
call bosch to see if it recall issue

Hi Friend,
U can download the Manual from the below link provided

http://kitchen.manualsonline.com/manuals/mfg/bosch/shy56a.html

Copy and paste the Link in the brower
in the web page will be having a download button click it u can view the manual

Or if its needed i can send u a mail kindly provide the mail id

Regards,
Ayyasamy

take it out and turn it upside down outside and go from there. At the edge of the counter underneath should be 2 screws that fasten it to the counter