Climate control suddenly stopped working. Sunroof no longer opening. Auto wiper for washer fluid pull not engaging. Rear defogger clicks on but no power on light. No in cabin circulation. Checked the main fuse box, and driver side compartment box. A/C SW fuse not receiving power.
SOURCE: blower fan
Sounds like the problem is more with the blower motor assembly itself. The blower motor have micro-proccers built itnto them which comunicate with the control heads and do the actual regulating of the fan motor. Dealers have computers with diagnostic software which allows them to monitor what is happening in the eletronic controls of the vehicle. Electronic diagnostics without the diagnostic software makes it very diffecult to pinpoint the actual item causing the problem.
SOURCE: Hyundai Accent 1998 Front Wiper and Washer Won't Turn Off
the black switches are master switches. They control stuff like the horn, the lights, wipers, AC, Engine Fans, and....there's one more that it controls, but i dont remember what it is. But you're going the wrong way about this. You're on the wrong side of the engine. You want to be on the opposite side of the engine, along the firewall, close to the front shocks by the windshield wiper motor. That's more than likely your problem. A little bit of water, grease, or some dirt might have slipped past the seal and caused a malfunction in the control wheel. Just open it up, clean it out, add some grease to the appropriate area, blow dry the circut board, stitch it back up, and that should solve the problem.
Please keep in mind that my American Car is a sligh bit different than your Australian Car. If the directions don't match up, i'm sorry for the inconvenience.
~Hope this helps
SOURCE: Where is the fuse for the ac blower motor in a
dear friend the fuse that you are looking for is in the engine compartment,if you open the fuse box look to the right hand side,right at the bottom,there is a 40amp fuse marked BLR,that is your blower fuse
SOURCE: 2003 Elantra GSL power windows don't work.
could be the driver side master window switch... if the driver side window switch assembly is broken then the windows will not work... try using a test light to see if you got power to the with and and ohm meter to check all four switches on the drivers side
57 views
Usually answered in minutes!
×