Threading diagram for rimoldi 3 thread serger model 627

Rimoldi 129 manual Google Search


you might try contacting a vendor who actually sells Rimoldi.

http://www.devicemanuals.com/productsupport/Brother_523n_manual.html


Even though this is not your model, the threading generally does not change greatly from one model to another. So, this may be helpful:

Make It Handmade Threading Your Serger or Overlocker

serger threading diagram Ask com YouTube Search

...

Viking 560 ED Huskylock Handbook

Threading Serger this may be helpful even if it is not the same model. The sequence of threading loopers is VERY important. If you thread them out of order, be prepared to be frustrated beyond belief!!! Something else (I don't think she mentioned) is to ALWAYS RAISE the presser foot when threading your machine. This is true for sergers AND sewing machines!

How to thread Serger

...

try this link and see if they have what you need http://www.sewusa.com/Sewing_Machine_Threading_Diagrams.htm

I have a Rimoldi 629 and to rethread the back part with the tube ...
you take of the front of the thread plate there is 2 screws...
then look down the left hand side you will see a dial ...
you need to take the 2 or 3 screws out of that panel and the dial actually holds it on just undo the dial a bit ...
you need to get some wire and thread it through the tube ... when it reaches the end of the tube make a tiny loop so that when you thread the back tension disk you can pull the thread through the tube ....
i have the proper threading guide if anyone need it
My email address is [email protected] just email me and i will send it to you

Hope this all makes sense thanks
Richard james

here is some links for a manual for the serger
http://sewingonline.co.uk/library/rimoldi-527-529.html
http://www.sewusa.com/Sewing_Machine_Manuals/Rimoldi_Sewing_Manuals/Rimoldi_527-529_Instruction_Manual.htm
or you can try youtube for a video

try youtube for a video or
a1sewingmachines.com or sewvacdoctor.com and ask them if they know where you can get a threading diagram
also check with sewusa.com and ask them

LOOPER ROTOS Y COMPRE UNOS NUEVOS PERO APARETEMENTE AL COLOCARLOS NO QUEDAN BIEN

You can look at youtube.com and see various sergers being threaded, also Brother at www.brother-usa.com, and www.singerco.com is quite helpful for threading a serger. All sergers pretty much thread the same way, remember always thread the 2nd from the right first. You can download your manual for free at the Brother site and enlarge the diagrams. Just take your time, it took me almost an hour to finally get it , now I can thread any machine without any problems. At first, I was very intimidated, but you will get it, really.

With some sergers, but not many (singer 14u64 comes to mind), the top of the stitch will be an overedge that mates with the right needle thread, and the left needle thread will appear as a separate straight stitch. When you look at the underside of the stitch, the overedge will go all the way over to the left needle (the full width of the stitch). This is normal if you have this type of machine. Another stitch some sergers do (2/4 thread sergers) is a 2 thread chain thal looks like a lone straight stitch on both sides, and a 2 thread separate overedge.

As far as the threading of the takeup, it totally depends on your model. Always post your model number when you have questions as sergers vary greatly in design.