Program my g.e remote control to a A.T.103 gematic digtal box

Set-up (Programming) procedure is too much to type in here, and is not practical and it will differ brand-to-brand remote controls. If you wish to get more; check the sites linked here. The site has set-up code list & set-up procedure to many popular brand remote controls. The site has general set-up codes to check with TVs and other devices are given, in the order of the 'device's brand name list' in alphabetical order. Set-up code list to many brand remote controls also is given. Pull up older posts. Search the sites by type in the brand name to your device in its search box at the top right part of the display window. It will help you to find the document easily.
http://remotesearch.blogspot.com/
http://electronicshelponline.blogspot.com/
http://electrohelponline.blogspot.com/
Programming Notes
• If your device does not respond to the remote after trying all codes listed or your brand is not listed in the code list, use the Auto Code Search method to program your remote.
• Sometimes the first code that "works" with your device may operate only a few functions of your device. There may be another code in the code list that performs more functions. Try other codes from the code list for more functionality.
This is a trial and error procedure; and quiet time consuming. You might have to check different codes said for your device

please use this secret take you r. control point upward the digital camera( you must get one) turn on the camera and from the display you must see the diode LED iluminating. see the picture ilustration. If not working you must open the r. control and clean the keypads for dirty, corrosion, grease. fix it.
God bless you

Hello
Setup codes for RCA TV with GE remote control are:

000 003 004 005 007 009 011 015 048

082 092 094 096 098 101 102 103 107
113 125 129 167 179 187 188 191 194
OK.

http://www.retrevo.com/support/Polaroid-FLM-2632-TVs-manual/id/279ag014/t/2/ link to manuel with Polaroid RC-103 codes and how to program remote. You have to give your Email address to get it.

Try these codes for your remote and TV. The are the Zenith codes for a Curtis Mathes TV.

CURTIS MATHES.....002 103
............................. 112 502 506
..................... 512 601 701 704

These should work.

Regards,

Mike

Here Are Some codes 000, 003, 004, 005. 006, 007, 019, 096, 098, 099, 100, 101, 102, 103, 129, 179, 181, 188, 190, 203, 212, 233. For t.v.'s............Hope this is help full.. : )

Here are the codes. 363, 073, 072, 095, 103

Here are the manuals.
http://www.universalremote.com/downloads.php

Good luck and Pleease rate FixYa!

Just a tv, (not a combo unit) the codes are as follows:

002
006
007
018
103
107
114
310
312
502
601
704
803
806
810
901
911

Press and hold the CODE SEARCH button until it stays lit, then release. Press and release the deired mode button (tv) and enter in a code. If the code is valid the red light will go out. You are done, if not, try another code by starting over.

Magnavox
103, 112, 113, 117, 119, 127, 128, 130, 139, 165
Zenith
101, 142, 149, 177

RCA DSS
373, 394
Zenith Satellite
312, 328, 330, 351