D23 on the board is blown up.I do not know what to order at the store.on the schematic I found it shows D23 with an E51A below it.Help. thanks

Here is the manual with the schematics for the unit. Unforunately it is large but I don't know which unit in the system you had the transistor blow. It will show you what the part specifications are for it and you can order a new one at an electronics parts supplier. I don't know if you have the ability to replace that yourself or not. If not someone at the store may be able to do it or direct you to someone who can. If the system is still under warranty, I highly recommend you have it fixed under the warranty. Here are the schematics pages:
https://docs.sony.com/release/MDSM/988974001_sm.pdf

Good luck

Wow. Blown IC!!!!!!!!!!!!!!!!
Best bet is to contact the manufacturer or get a hold of the schematic for the control board.

If unsuccessful you may be able to buy a replacement on the cheap on ebay and get parts.

I don't see any schematics either but there are several boards listed on ebay. Perhaps you can contact the seller and ask them to kindly read the component value to you.

With out knowing the year and model of your motorcycle it would be hard to get you a picture. But you can look up a break down of your rear wheel and axle at Bikebandit.com in the OEM parts section.

Go to eReplacementParts.com : Power Tool Parts and Tool Repair.

http://www.go-gddq.com/upload/2009_08/09081816054725.pdf

Let me know if this helps you..

Please take time to vote a thumbs-up :)

Issues where water has been splashed onto the board can cause so many weard issues, it is easyer to replace the board then try to replace the individual parts. You need to do allot of troublshooting that will requrie schematic and a good knowlage of that board. try to get your board from pts, http://www.moduslinkptstvboards.com/

hi there,

you can try to this store to order the parts to be replaced part number & description was also indicated in HERE.

just let me know, for further assistance,

All lights come on HP Pavilion dv1000 but will not boot. looked at motherboard and by power connector there is a blown part the number on the board shows PD27. I need to know what thhe part is or a schematic showing