They are not working

If you need an unlock code, try the last 4 digits of your cell phone number.

If that does not work, contact you telephone service provider or the vendor you purchased the telephone from if not ur telephone service provider.

If this information was helpful, please remember to leave positive feedback. If you need further assistance, please provide your telephone make and model number.

Thank You,

Brian

You can download the manual at
http://www.home-electronics.net/ge/pc/IB/29897GE1_IB.pdf

Without the age and model number makes it a problem diagnosing. However, it is not unheard of for a cold control (thermostat) to shut off the machine and hang up and refuse to return to the on position. The cold control on temp is usually about 37 degrees. If left off for 8 hours, the sensing bulb on the thermostat would reach room temperature, and with that additional temperature (heat) could cause enough pressure on a balky thermostat to reset to the on position.

Try these codes for dynex televisions. Dynex Television 1023, 1107, 1122, 1273, 1382, 1383, 1384 If these codes do not work you can call the Dynex customer support at this telephone number 1-800-305-2204. Give them the model number of you television and ask them how to get the code. I hope this information helps you with your problem.

I just found the part that I think you need. It's part no. WB7X7220
It's available through the GE parts and accessories store.

I use a ATT calling card I put the 1-800 number and stored it in A then stored the pin# in B it will go throught ,so try to dial it in
manualy
it still will work . But the same works on our phones.Could it be dialing in an Area code?

try the last 4 digits of your mobile telephone number

There is an undocumented solution to link difficult devices. Instead of pushing ad releasing, hold either button down until you get a FAST BLINK and then try linking again.

Just purchased the GE 25922 today. Looks like you can skip (ignore) the option to enter an area code.

United States' Area Codes are three-digit numbers. If the phone 'requires' entering a number you can use any three digit number. The purpose of this option is to display a local telephone number with only the 7 digits.

Example:
603 - 123 - 4567
'603' is the area code
123-4567 is the 7-digit local number.

If the area code option is programmed to '603', then if that number called '123-4567' would display on the Caller ID display.
Which now reminds me: you would need to also subscribe to Caller ID with the Telephone Company for the numberic display to occur.