How to connect powercord to recoil - Garden

To convert it its possible more expensive then buy an other grinder but there is some trick to connect in serial on the powercord a light bulb on a special choosen ability differs on the RPM or use a variable power resistor also in serial connection between on one of the 2 wires on the powercord.

The pull starter connects to the recoil starter which sits on top of the engine. When the string breaks, it can be rewound or you can buy a new recoil starter @ Jiffy http://www.jiffyonice.com/EComStore/pages/home.aspx

what type of motor

Replace the power cable and data cable. If still no help, the drive is dead and needs to be replaced.

I would contact the maker OR Google the model number with "power cord" to find one.

Does it have the battery in it? If so, plug the powercord in to charge. If not, put the battery in it. If it still doesn't work with battery and power cord: I would think either the battery or the powercord is not working properly. Most likely the powercord.

call ur isp ...ask for

1. ip address
2.subnet mask
3.default gateway
4.dns
or
1.ppoe - username and password

============
connect ur belkin to the computer
1. start - run - cmd - enter
u get a command prompt screen
2. type ipconfig
u will get the default gateway
close that black screen
3.open the internet explorer
4. type the default gate way in the address bar
5. it will ask for the user name and psw for belkin
6. check ur manual for default user id and the psw
7. u can see the main page of belkin
8. enter the first set of settings or the second set
save
==============i hope this will help u

Look for a friend around and trouble shoot swapping the power cords. But I believe it must be your power cord that should be replaced.

Do the trouble shooting before replacing.

Rate this, please.

In the bottom of the laptop you can find the input required, make sure the voltage matches the requirement and the connection is the right way.

from what you said I can't tell if its too stong, can you adjust the voltage? look in the bottom it is documented there on a label.

It has a cord relief to hold the cord in near the bottom, you will have to pull that out, the cord goes in there and comes out by the motor where the the wires connect. So you will have to pull the motor cover off to get to where they hook up to.