Hoover 800F1AUS front loader. Control Panel Fascia operating instructions. I got it 2nd hand and some of the symbols are worn off. I,ve seen others ask this question but no links were successful.

SOURCE: Eurotech MA66 front loader user manual

Click on washing machines (below FIXYA )on this website, type in your model number & search. You will get a shortlist; click on your model, below the page u will get Manual/Guides. Click on the blue, you will hv your manual on line. If available that is.

And rate me pl if helped............

SOURCE: unlock the control panel to a kenmore elite front loader

to unlock the controls
select and hold drain/spin for 3 seconds until the control locked status lights turn off.

SOURCE: KUDS25SHWH1 Kitchenaid Dishwasher Control Panel Only CANCEL light on

I bought a control board for $127.00 figuring that was the problem but it wasn't. I called an appliance guy who came out and said its the touchpad that needs to be replaced. I ordered the touchpad ($325) since I already have to much invested in this dishwasher. I paid $1200 for it 8 years ago and its really a great dishwasher. My appliance confirmed that if it was the fuse-ling that you would not have any lights on.

SOURCE: OPERATING INSTRUCTIONS FOR SOVEREIGN/MOUNTFIELD COMPACT RIDER LAW

I see that is a British machine. I've looked everywhere and it seem they do not have operator's manuals online. Your best bet is call the manufacture in England. It seem they don't have any American distributors. The number is 0-845-600-3207. The 0 is the country code and you'll need to dial it. If you get an operator they can help. I've never called England so good luck.

SOURCE: Program factory remote keyless entry: 2003 Hyundai XG350

The procedures you list require the Hyundai Keyless Remote programming module, which you don't have. This module is proprietary - only Hyundai Dealerships have it. There is a 10 pin connector under the dash (next to the DLC - Data Link Connector) which is used to connect the Keyless Remote Programming Module. This module has two switch positions "Ready" and "SAVE". When the switch is place in the 'SAVE" position, that's when the keyless remotes are activated to send their 'codes' to the Electronic Time and Control System (ETACS). The module's switch is then set to "Ready" and the remote is tested to see if it works properly.