What does the blue snow flake mean on the display

Hello,

Simple th E means error
That e20 then mean error 20 which mean timing will need to be restet .check on the timing bello or beside the display start reduce the timing and the problem solve.

Thanks .

about 3 will do it for a start, you want the freezer to be at or below zero degrees Fahrenheit.

you have to defrost the freezer the old fashion way...which means it does not do it on its own....you have to shut down the refrigerator in order for it to start melting...and then sop up any water with towels or bowls....key is to never let it get full of snow, so it's easier to do.....another way to defrost it, which I do...is to take a wooden spoon, never metal....and just scrape out the layers of snow that has formed into a bowl as you scrape, put the bowl inside and just scrape it into it.......if you do that once a month, it should keep the snow from too much buildup....I love my IGLOO it's perfect for just me and my condo....and I just redid my kitchen.....however after 2 years now, it's not cooling too well, which I have read other comments that this happens...

Sounds like the water valve is not fully closing allowing water to still enter.

CALL Chas&Son,s at 570-379-0993 and they will come out the same day no less okay

If you are noticing that you often have "snow" if the freezer, this is an indication of one of two things. 1. Are you putting food into the freezer while it is still hot? This will cause condisation to form, and if it is done often enough, this will lead to "snow" 2. The other reason that this might happen, and the more likely of the two is that the door is either not being closed completely, or the door seal is leaking allowing room air to enter and condense in the freezer. Hope this helps.

Does it sound like it is never shutting off/ It may mean it is over freezing. Also for good measure >>>>
Is your circulating fan working?
Sometimes they stick and need a shot of WD 40 and then work
it back and forth a little until it wants to take off again. Keep me informed
and PLEASE give a Thumbs Up for the effort. The Raz Shack

That could be one of two things, one the door is not aligned properly and more important the gasket has failed and needs replacement. The snow as you call it is ice condensed from the atmospheric air that is getting by the gasket. You may want to check the door gasket and sealing surfaces especially in the area of the "snow".
Good luck,
Gilshultz

You need to replace this pc board, your unit seems to be short cycling because of a fault on the defrost side of the board.

what u mean by defrosted? was the evap. coils all frosted up ..looks like snow there?