Cant open the front door seems like its locked

rough usage of door handle bends internal mechainism,you will need to remove door panel iside car and replace door opening mechanism or repair it

nice double post., we will print them both out and do wall paper.
LOL!

just get an old door from any ariston..hotpoint or indersit machine make sure it is the same size

(door lock actuator)all doors have one in them, they weeken, and sometimes work to open, and some times to lock, or not at all. only fix is to replace each of them as they go out, usually cost abt 20 to 40 bucks a piece

You need to replace the door lock/switch. It is quite an easy job but is a tight fit behind the front so a bit tricky to get the old one out and the new one in.

replace the outside door handle. happened to me with same car, had to replace both handles. poor design causes the lifter arm to bend and eventally causes it to not lift enought to open the door.

there is a lock release tab accessible from lower cover on bottom of lock asm. open cover and pull tab down. replace door lock asm.

The main cause with this model is water still in machine. Try a spin and look for water in drum. To empty manually lower drain hose into bowl untill empty. Door should then open.

TO OPEN THE DOOR YOU WILL HAVE TO TAKE THE 3 SCREWS AT THE BOTTOM OF THE KICKPLATE OFF USE TORX OR T15 BIT TO REMOVE SCREWS. PULL DOWN ON THE PANEL AND IT SHOULD RELEASE ONCE REMOVE FEEL THE INSIDE OF THE DOOR PANEL AROUND THE DOOR LOCK AREA U SHOULD FEEL A OVAL RING AT THE BOTTOM OF THE DOORLOCK ASSEMBLY PULL DOWN ON THAT RING AND THE DOOR WILL OPEN

If you need further help, reach me via phone at https://www.6ya.com/expert/marlon_56d9a24f02585258