Where is the speed sensor located for my 03vw jetter 1.8 t

Question editerd for clarity.

Question moved to model category, however, there are 3 engine sizes for that model.

VEHICLE 2008 Jeep Commander
All

Parts

Accessories

3.7L Gas; Engine
4.7L Gas; Engine
5.7L Gas; Engine
That part from AUTOZONE!!

2008 Jeep Commander Vehicle/Transmission Speed Sensor AutoZone

https://www.autozone.com/engine-management/vehicle-transmission-speed-sensor/jeep/commander/2008
.

P0717 OBD-II Trouble Code: Input/Turbine Speed Sensor ...

YourMechanic https://www.yourmechanic.com > Articles
P0717 is a diagnostic trouble code (DTC) for "Input/Turbine Speed Sensor No Signal". This can happen for multiple reasons and a mechanic needs to diagnose ...

Missing: Commander ‎' Show results with: Commander

Code P0717 Jeep Input Speed Sensor 1 Circuit No Signal

AutoCodes https://www.autocodes.com > p0717_jeep
Repair Information for P0717 Jeep code. Learn what Input Speed Sensor 1 Circuit No Signal means, location and how to repair?

Similar to this

https://jeepspecs.com/wj-generation/wj-jeep-parts-equipment/transmission-input-output-speed-sensors/

..

https://www.google.com/search?q=2007+Ford+Focus+speed+sensor+locations

Where is the 2007 ford focus speed sensor located?

Vehicle History https://www.vehiclehistory.com > questions > where-is...
Located on the right side of the transmission near the output shaft. Like. (1). Leave your answer.
2 answers · Top answer: The 2007 Ford Focus speed sensor is found by watching: https://www.Youtube.com/watch?v=jxqItE9OI20 You will come into many issues with an engine. A gasket ...

2007 Ford Focus Sensor Locations

Rick's Free Auto Repair Advice https://ricksfreeautorepairadvice.com > 2007-ford-foc...
Oct 3, 2018 - Wheel Speed Sensor (Left Rear) (Wagon) At left rear wheel. Wheel Speed Sensor (Left Rear) (3 Door) At left rear wheel. Wheel Speed Sensor (Left ...

2005 kia optima: my input shaft speed sensor located ...

https://www.justanswer.com > Car Questions
Jul 27, 2010 - The input shaft speed sensor is located on top of the transmission Just under the Air Filter. So you will have to remove the Air Filter and you ...
1 answer · Top answer: Hi thank you for your question hope this helps. The input shaft speed sensor.

Videos as well

https://www.google.com/search?q=2005+Kia+Sedona+Location+of+input+turbine+speed+sensor+for+automatic+transmission

..

On a 2001 Jeep Cherokee Sport (XJ), there are typically two speed sensors: the vehicle speed sensor (VSS) and the rear axle speed sensor. The VSS is located on the transmission or transfer case, while the rear axle speed sensor is located on the rear differential housing. Here are some tips to locate the rear axle speed sensor: 1. Locate the rear differential housing: The rear differential is typically positioned towards the rear of the vehicle, underneath the rear cargo area. Look for the large metal housing connected to the rear axle. 2. Identify the speed sensor: The rear axle speed sensor is usually mounted on the differential housing itself. It will have a wiring harness connected to it. 3. Follow the wiring harness: Trace the wiring harness from the rear axle speed sensor. It will lead you to a connector that is plugged into the vehicle's wiring system. The connector may be located near the rear axle or along the frame. 4. Inspect the differential housing: Look closely at the differential housing for a small protrusion with a threaded hole. This is where the rear axle speed sensor is installed. It may have a retaining bolt securing it in place.

Try this:

images for location of mass air sensor in 2012 jetta

and this: https://axleaddict.com/auto-repair/clean-replace-vw-audi-maf-diy

Are you looking for the wheel speed sensor or the vehicle speed sensor?
The wheel speed sensor is located on the steering knuckles just behind the rotors.
The vehicle speed sensor is located on top of the transmission housing under the air filter bock housing.

If you need any more info or details on these sensors, let me know.
Hope this helps you.

A wheel speed sensor?

They are located at each individual wheel.

An output or input speed sensor?

They are located on the drivers side of the transmission. They are yellowish white in color and look identical to each other. You will need a 1 inch socket to remove and replace them.

The input speed sensor is towards the front of the transmission and the output speed sensor is located toward the rear of the transmission.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

LEVEL CHECK -manual transmission The vehicle speed sensor (speedometer gear), which is located on the transaxle, serves as the manual transaxle's dipstick.

1. Park the car on a level surface, turn the engine OFF and apply the parking brake.
2. Locate the speedometer cable assembly where it enters the transaxle.
3. Unplug the electrical connection from the vehicle speed sensor (speedometer gear).
4. Disconnect the speedometer cable from the speed sensor.
5. Wipe the area around the speed sensor with a clean rag, then loosen the speed sensor retaining bolt.
6. Gently pry the speed sensor from the transaxle. Fig. 1: Location of the manual transaxle's fluid level marks — 1.8L engine
   Fig. 2: Location of the manual transaxle's fluid level marks — 1.9L and 2.0L engines
   
   
7. Check the condition of the speed sensor O-ring and replace it if it is damaged.
8. Check the fluid level on the speed sensor as illustrated.
9. If the level is low, place a funnel in the speed sensor hole.
10. Add the specified fluid to the transaxle until the FULL level is reached. Do not overfill the transaxle.
11. Install the speed sensor and tighten the retaining bolt to 69–104 inch lbs. (8–12 Nm).
12. Connect the speedometer cable.
13. Engage the speed sensor electrical connection. Fig. 3: If necessary, add transmission fluid through a funnel into the speed sensor opening
    

They are not the sensors you want. The car uses the abs wheel sensors for vehicle speed. Your problem lies in the abs system , possibly the left front sensor, abs ecu or speedo cluster, Clear the code and see if it stay out otherwise you'll need to go to a trusted technician. .

Your car has the 4L60E trans,and the speed sensor is located in the tailshaft of the trans.The tailshaft is located on the rear of the trans,and is held onto the trans with 4,15mm bolts.The driveshaft slips into the tailshaft.The speed sensor will have at least 2 wires going to it.The speed sensor will be located either on the driverside or passenger side of the trans.95 was a transitional year,so the speed sensor could have been mounted on either side.Good luck