Can i but a new barrel how much - Gamo Bone Collector .177 Caliber Hunting Pellet 150

Sometimes you have to put the key in the barrell and there should be a small recess or button you push push and barrel will come out

Contact the manufacturer for this information - or Pyramid Air, they are the experts in air guns.

there not rivets, use a small tooth saw blade (hacksaw) cut a slot then use a flat blade screw driver and under as a normal screw. then you can use them to put new barrel back in. hope this helps

sounds like the inside workings of the barrel are worn out or broken. you will probably need to take the barrel out and replace it . Before you put the new barrel in you may need to take both new and old barrel to a locksmith and get them to change the slides over from the old one to the new one, or you can do it yourself but it is a bit fiddly. If you don't change the slides then the new ignition key won't fit the doors as well as the ignition. hope this helps

replace the whole ignition barrel with new key and get key programmed by dealer
can remove barrel and key by removing steering column covers turn ignition to on position and with small shank screw driver push in hole in outer top rear section of barrel assembly then pull out ignition lock barrel with key in it. fit new lock barrel and key, program new key into system and can get door lock barrels coded to suit new key or get code for old key and cut new key so it fits mechanical locks on the rest of the vehicle (just wont turn in ignition) 2 keys for vehicle.

you will have to split the ignition barrel, using either a hammer and small thin chisel or an old screw driver, if you split both side opposite the barrel will fall out, it will in some cases leave the barrel stalk in the black box (the electrical black plastic box at the other side of the barrel housing) to remove this turn with a screwdriver to either position 1 or position 2, at the front of the barrel housing is a release pin hole which will need a small allen key or pot rivet pushing into it to release the barrel stalk, remove with pliars or with flat blade screw drive, place key in new barrell hold thumb over secure pin holding it into the new barrel, then gently turn key 90 degrees, and offer into barrel housing, ensure the secure pin is at all time still into the barrel, slide the barrel into houseing slowly until you mate up the barrel stalk to the black box, and slide in until you hear the secure pin click into place, turn key back to zere and remove slowly, the new barrel is fitted. should take about an hour from start to finish, if it was not seized no more than 15 min to complete. hope this helps.

not saying it is landrover barrel but best way is get your new barrel and that should tell you how it is fitted normally a spring loaded pin holds barrel in socket

did u try changing code reader on the barrell? it mite not be picking up the code on the key

Sounds like a faulty ignition barrel! If you take off the trims underneath the steering column you'll be able to gain access to the ignition barrel casing where the key goes. By undoing the casing you'll be able to turn off the engine with a simple flat bladed screwdriver.

Ignition barrels arent too expensive to have replaced, the other problem that might occur is the chance of needing a new set of keys or to have your current keys programmed to the new barrel (Normally a new set of keys is the common procedure with a new barrel)!

Hope this helps

it is better to buy a new ignition barrel.it takes a special socket to get the screws out, once the screws are out they do not need to be replaced.buy new barrel,disconnect negative battery cable,disconnect wires from barrel assembly, remove barrel from colum. first take vin# to dealership parts department to get correct barrel assembly, the keys with new assembly will fit doors and trunk